Nozzles

OPERATING INSTRUCTIONS

Throttle

STEP 7: Turn the engine to "Run" position.

STEP 8: Pull the starter grip. If the engine fails to start after 2 pulls, squeeze the trigger gun to release pres- sure and repeat step. Return starter gently. After the engine warms up enough to run smoothly, move choke to run position and throttle to fast position.

CAUTION: Small engines may kick back. Do not hold pull starter grip tightly in hand.

Temperature

Gauge

Burner

Switch

STEP 8: If hot water is required. Adjust temperature gauge to proper temperature (200°). Turn on Burner switch to begin heating water.

Safety

Latch

WARNING! Never replace nozzles without engaging the safety latch on the spray gun trigger.

The four color-coded quick con- nect nozzles provide a wide array of spray widths from 0° to 45° and are easily accessible when placed in the convenient rubber nozzle holder,

PRESSURE WASHER OPERATOR’S MANUAL

	Brass Soap
	Nozzle	Variable Pressure
		Variable Pressure
		Wand (VP)
	High
	Pressure
	Nozzle
	Variable Pressure	Trigger
	Control Handle	Trigger
	Control Handle

which is provided on the front of the machine.

NOTE: For a more gentle rinse, select the white 40° or green 25° nozzle. To scour the surface, select the yellow 15° or red 0° nozzle. To apply detergent select the black nozzle.

Selection of high or low pressure is accompanied by turning the handle. Note: High pressure nozzle must be inserted at end of wand to obtain high pressure. To apply soap read operator's manual.

97-6132, 97-6151 • REV. 11/04