ASSEMBLY INSTRUCTIONS | PRESSURE | |||
Spray |
| Coupler | ||
Gun | Soap | Nozzle |
| |
| Nozzle | Wand |
| |
|
|
| ||
Safety | Wand |
| WASHER | |
Hose | Coupler |
| ||
Latch |
|
| ||
|
| Wand |
| |
High Pressure |
| Collar |
| |
|
| OPERATOR’S | ||
STEP 1: Attach the high pressure | STEP 2: Pull the | STEP 3: Release the coupler collar | ||
| ||||
hose to the spray gun using teflon | collar of the wand coupler back | and push the nozzle until the collar |
| |
tape on hose threads. | to insert your choice of pressure | clicks. Pull the nozzle to make sure |
| |
| nozzle. | it is seated properly. | MANUAL | |
DipStick |
| Water | ||
| Cold |
| ||
|
| Source |
| |
| Discharge |
|
| |
| Fitting |
|
| |
| Coupler Collar | Garden |
| |
|
|
| ||
| High Pressure Hose | Hose |
| |
|
|
| ||
STEP 4: Remove shipping cap and | STEP 5: Connect the high pres- | STEP 6: Connect garden hose to |
install oil dipstick. Check pump oil | sure hose to the pump discharge | the cold water source. |
level by using dipstick or observe | fitting. Push coupler collar forward |
|
oil level in oil window (if equipped). | until secure. |
|
Use 30 wt. non detergent oil. |
|
|
Garden |
Hose |
Pump |
Water Inlet |
STEP7: Connect the garden hose to pump water inlet. Inspect inlets.
CAUTION: Do not run the pump without water or pump damage will result.
7