Subaru Robin Power Products RGX3510 Rotor Assembly, Condenser, MODEL II RGXl810, RGX2410, RGX5510

9-5ROTOR ASSEMBLY

(1)Using a "Dr. Robin" or a circuit tester, measure the resistanceof the field coil at the terminals.

MODEL II RGXl810

RESISTANCE2.0R

I

	!i		i	( 0 )
RGX2410		RGX3510		RGX5510
	I
1.88 R		1.74 R		1.62R

Table 9-2

NOTE 1: Because a diode is soldered to the coil ends at the terminals, resistance may be measured only when tester probes touche the terminals in one combi- nation of polarity. Therefore, if no re- sistance reading appears, try checking in reverse polarity.

NOTE 2: If the circuit tester is not sufficiently accurate, it may not show the values given and may give erroneous readings.

Erroneous reading will also occur when there is a wide variation of resistance among coil windings or when meas- urement is performed at embient tem- peratures different from 20°C(68"F).

9-6CONDENSER

1

j

i!

!

!

j

Fig. 9-5

!

I

Use a "Dr. Robin" in capacitance meter mode to check the capacityof condensers. (See Fig.9-6).

i

I

I

RGXl810, RGX2410 RGX3510 RGX5510 i

Fig. 9-6

NOTE: Be sure to discharge condensers by shorting condenser leads each other before checking their capacitance,or the accurate reading cannot be obtained.

- 40 -