Subaru Robin Power Products RGX3510 manual

(4) CheckthewiringthroughZCT			on theIDLE
CONTROL UNIT BOARD.
0 Single Voltage Type
Make sure that an output wire from main coil is
passing	throughthe	ZCT	on	theIDLE
CONTROL UNIT.
0 Dual Voltage Type
Check that two output wires (black wire and red
wire)frommain		coilsarepassing		through the	I DL €
ZCT on	theIDLECONTROLUNIT			inthe
					UNIT
same direction.					CONTROL3Fig. 11-14

( 5 ) Checking the IDLE CONTROL UXIT

Check the resistance between six leadsof IDLE CONTROLUNIT with circuit tester.

. .\ . .

IDLE CONTROL UNIT

Fig. 11-15

I	Tester Polaritv	I
		I

LIGHT BLUE (FUSE)

I

BLUELIGHT20-50kQ2-16kQ . :

Tzble 1 1-4

NOTE : Take 510% tolerance on above resistance value.

If the measurement differs largely from mormal value, the IDLE CONTROL UNIT is defective. Replace with a new one.

- 72 -