Subaru Robin Power Products RGX3510 manual M4 screw, “4 ScreLV, M4 scre\v

10-4 CHECKING, DISASSEMBLY and REASSEMBLY of the CONTROL BOX

10-4-1 CHECKING OF THECONTROLBOX

Dismount the control box from frame.

Remove the control panel and check each components and wiring.

Refer to Section 9 for the detail of checking procedure for the components in the control box.

10-4-2 DISASSEMBLY

(1) Remove the control panel from the control box.

screw	6 pcs. (RGX1810, RGX2410, RGX3510)
M4 screw	8 pcs. (RGX5510)

(2)Disconnect the connectors on the wiresto detach the control panel and box.

(3)Remove the condensers and diode rectifier from the control box.

(4)After disconnecting individual wires, remove the control panel components.

NOTE : DC fuse, full power switch and pilot lamp have their wires soldered. Unsolder them to remove those parts if necessary.

10-4-3 REASSEMBLY

(1)Installthereceptacles,no-fusebreaker,fuse,terminals,switches,etc.onthecontrolpanelandwire them.

NOTE : Circuit diagrams are shown in Section 12. Colored wires are used for easy identification, and are of the correct capacity and size. Use heat-resistant type wires (permissible temperature range 75°C or over) in the specified gauge shown in the circuit diagrams.

(3)Install condensers, and diode rectifier into the control box.

(3)Connect the wires of control panel components and control box.

Fastentheearthwires to the rear of thecontrolboxusinga M4 nut totheboltwhichfixesthe condenser bracket to the inside of the control box. (See Fig.10-30.)

Attach the control panel to the control box.
“4 ScreLV	6 pcs. (RGX1810, RGX2410, RGX3510)
M4 scre\v	8 pcs. (RGX5510)		1.2 - 1.5 Nom
REAR COVER	CLAMP	M4 NUT	WELDING NUT
	E A R T H WIRES		To EARTH TERMINAL

,CONDENSERBRACKET

I

II

II

I

Fig. 10-30

- 65 -