Subaru Robin Power Products RGX3510 manual Checkingtablefordigitalcircuittester, OIL Sensoroption

WCheckingtablefordigitalcircuittester.

		!	Apply red @needle of the circuit tester
Digital circuit tester		1	Brown	I	Brown	I	Orange		Brown;White
				j
	Brown			1-	NO continuity	i	NO continuity I		Ccntinuity
0	Brown	I	NO contir;uity				No coniinuiiy	i	Continuity
Apply black needle		I		!
of the circuit tester	Orange.		Continuity		Continuity	,			Continuity
		i		i
’	Brown;White	I	No continuity	I	No ccntinuity		No continuity

Table 9-4-2

NOTE 1: Because of the difference of measuring method between the analogue circuit tester and the digital circuit tester, polarity of tester needles should be reversed.

NOTE 2: ‘Continuity” means forward direction characteristics of the diode, and different from short circuit condition (in which a pointer of the tester goes outof its normal scale), shows resistance to some extent.When results of the checking indicates failure even in one section,replace with a new one.

NOTE 3: Simpson brand analogue testers have the characteristics as same as the digital circuit tester.

9-8 OIL SENSOR(OPTION)

1.Disconnect tn-o (2) .\%-irescomming fromthe sensor at the connection.

2. Loosen the sensor to remove it from the engine.

3.Plug the opening of oil filler hole (created after sensor is removed) with suitable means such as oil gauge.

I

4.Connecttheremovedwiresagainwiththeoil sensor.

I

5 . Start the engine with the oil sensor removed and	Fig. 9-9
confirm if;
a. Engine stops after 5 seconds which is normal, or
b. Engine does not stop after more than 10 seconds which isunusual.

NOTE : The sensor .will not operate properly when wire is broken or poorly connected. Check the -wires forcorrect connection.

If it fails to stop within 5 seconds after the wirings have checked, the sensor is wrong. Replace the sensor with new one.

- 50 -