Front I/O, Power Switch Assembly
Description | Spare part number |
|
|
Front I/O and power switch assembly | |
|
|
The front I/O and power switch/LEDs is one assembly, attached to the front of the chassis. Push the assembly into the chassis to remove.
1.Prepare the computer for disassembly (Preparation for Disassembly on page 99).
2.Remove the access panel (Access Panel on page 100).
3.Remove the front bezel (Front Bezel on page 101).
4.Remove the chassis fan (Front Fan Assembly on page 133).
5.Rotate the drive cage to its upright position.
6.Disconnect the four cables from the system board as follows:
●Yellow connector labeled FRONT_USB
●Green connector labeled FRONT_USB2
●Blue connector labeled FRONT AUD
●Black connector labeled PB/LED
Figure 7-41 Disconnecting the front I/O, power switch/LED assembly cables
7.Remove the Torx T15 screw (1) that secures the assembly to the front of the chassis.
136 | Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis |
