5.Connect the appropriate drive cables:
a.If installing a second hard drive, connect the power cable (1) and data cable (2) to the rear of the drive and connect the other end of the data cable to the light blue connector on the system board labeled SATA1.
Figure 7-23 Connecting the Secondary Hard Drive Power Cable and Data Cable
b.If installing a media card reader, connect the USB cable from the media card reader to the USB connector on the system board labeled MEDIA.
Figure 7-24 Connecting the Media Card Reader USB Cable
NOTE: Refer to System Board Connections on page 115 for an illustration of the system board drive connectors.
6.Replace the 5.25-inch drive.
7.Replace the front bezel (if removed) and access panel.
8.If the computer was on a stand, replace the stand.
124 | Chapter 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis |
