HP Pro 6305 manual Installing a 3.5-inch Drive into a Drive Bay

Installing a 3.5-inch Drive into a Drive Bay

The 3.5-inch bay is located underneath the 5.25-inch drive. To install a drive into the 3.5-inch bay:

NOTE: Install guide screws to ensure the drive will line up correctly in the drive cage and lock in place. HP has provided extra guide screws for the drive bays (four 6-32 standard screws and four M3 metric screws), installed in the front of the chassis, under the front bezel. A secondary hard drive uses 6-32 standard screws. All other drives (except the primary hard drive) use M3 metric screws. The HP- supplied M3 metric screws are black and the HP-supplied 6-32 standard screws are silver. Refer to Installing and Removing Drives on page 117 for illustrations of the guide screw locations.

1.Follow the procedure in Removing a 5.25-inch Drive from a Drive Bay on page 119 to remove the 5.25-inch drive and access the 3.5-inch drive bay.

CAUTION: Ensure that the computer is turned off and that the power cord is disconnected from the electrical outlet before proceeding.

2.If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then remove the bezel blank. See Bezel Blanks on page 104 for more information.

3.Install guide screws in the holes on each side of the drive.

Figure 7-21Installing Guide Screws (Media Card Reader Shown)

4.Position the guide screws on the drive into the J-slots in the drive bay. Then slide the drive toward the front of the computer until it locks into place.

Figure 7-22Installing a Drive into the 3.5-inch Drive Bay (Media Card Reader Shown)

Drives 123