
Table 10-1 Numeric Codes and Text Messages (continued)
Control panel message | Description | Recommended action |
|
|
|
Computer cover was removed since last | No action required. | |
Since Last System Startup | system startup. |
|
|
|
|
Front audio harness has been detached or | Reconnect or replace front audio harness. | |
| unseated from motherboard. |
|
|
|
|
Front USB harness has been detached or | Reconnect or replace front USB harness. | |
| unseated from motherboard. |
|
|
|
|
There is an incompatibility/problem with this | Try rebooting the system. If the error | |
initialize | device and the system or PCI Express Link | reoccurs, the device may not work with this |
| could not be retrained to an x1. | system |
1.Remove any serial port expansion cards.
2.Clear CMOS. (See Appendix B, Password Security and Resetting CMOS on page 199.)
3.Reconfigure card resources and/or run Computer Setup or Windows utilities.
1.Remove any serial port expansion cards.
2.Clear CMOS. (See Appendix B, Password Security and Resetting CMOS on page 199.)
3.Reconfigure card resources and/or run Computer Setup or Windows utilities.
Both external and internal serial ports are | |
| assigned to same IRQ. |
1.Remove any serial port expansion cards.
2.Clear CMOS. (See Appendix B, Password Security and Resetting CMOS on page 199.)
3.Reconfigure card resources and/or run Computer Setup or Windows utilities.
Hard drive is about to fail. (Some hard | 1. | Determine if hard drive is giving correct | |
Failure | drives have a hard drive firmware patch that |
| error message. Enter Computer Setup |
| will fix an erroneous error message.) |
| and run the Drive Protection System test |
|
|
| under Storage > DPS |
|
| 2. | Apply hard drive firmware patch |
|
|
| if applicable. (Available at |
|
|
| http://www.hp.com/support.) |
|
| 3. | Back up contents and replace hard |
|
|
| drive. |
|
|
| |
One or more SATA devices are improperly | Ensure SATA connectors are used in | ||
| attached. For optimal performance, the | ascending order. For one device, use SATA | |
| SATA 0 and SATA 1 connectors must be | 0. For two devices, use SATA 0 and SATA | |
| used before SATA 2 and SATA 3. | 1. For three devices, use SATA 0, SATA 1, | |
|
| and SATA 2. | |
|
|
|
|