HP Pro 6305 manual Control panel message Description

Table 10-1Numeric Codes and Text Messages (continued)

Control panel message Description Recommended action

1797-SATA Drivelock is not supported in RAID mode.

Drivelock is enabled on one or more SATA hard drives, and they cannot be accessed while the system is configured for RAID mode.

Either remove the Drivelocked SATA device or disable the Drivelock feature. To disable the Drivelock feature, enter Computer Setup, change Storage > Storage Options > SATA Emulation to IDE, and select File > Save Changes and Exit. Reenter Computer Setup and select Security > Drivelock Security. For each listed Drivelock-capable SATA device, ensure Drivelock is Disabled. Lastly, change Storage > Storage Options > SATA Emulation back to RAID and select File > Save Changes and Exit.

1801-Microcode Patch Error	Processor is not supported by ROM BIOS.	1.	Upgrade BIOS to proper version.
		2.	Change the processor.
2200-PMM Allocation Error during MEBx	Memory error during POST execution of the	1.	Reboot the computer.
Download	Management Engine (ME) BIOS Extensions	2.	Unplug the power cord, re-seat the
	option ROM.
			memory modules, and reboot the
			computer.
		3.	If the memory configuration was
			recently changed, unplug the computer,
			restore the original memory
			configuration, and reboot the computer.
		4.	If the error persists, replace the system
			board.
2201-MEBx Module did not checksum	Memory error during POST execution of the	1.	Reboot the computer.
correctly	Management Engine (ME) BIOS Extensions	2.	Unplug the power cord, re-seat the
	option ROM.
			memory modules, and reboot the
			computer.
		3.	If the memory configuration was
			recently changed, unplug the power
			cord, restore the original memory
			configuration, and reboot the computer.
		4.	If the error persists, replace the system
			board.
2202-PMM Deallocation Error during MEBx	Memory error during POST execution of the	1.	Reboot the computer.
cleanup	Management Engine (ME) BIOS Extensions	2.	Unplug the power cord, re-seat the
	option ROM.
			memory modules, and reboot the
			computer.
		3.	If the memory configuration was
			recently changed, unplug the power
			cord, restore the original memory
			configuration, and reboot the computer.
		4.	If the error persists, replace the system
			board.

192 Chapter 10 POST Error Messages