Table 8-14Solving CD-ROM and DVD Problems (continued)

Drive not found (identified).

Cause

Solution

 

 

The system may not have automatically recognized a newly

See reconfiguration directions in the Solving Hardware

installed device.

Installation Problems on page 169 section. If the system still

 

does not recognize the new device, check to see if the device

 

is listed within Computer Setup. If it is listed, the probable

 

cause is a driver problem. If it is not listed, the probable cause

 

is a hardware problem.

 

If this is a newly installed drive, run the Computer Setup utility

 

and try adding a POST delay under Advanced > Power-

 

On Options.

 

 

The device is attached to a SATA port that has been hidden in

Run the Computer Setup utility and ensure Device Available

Computer Setup.

is selected for the device's SATA port in Security > Device

 

Security.

 

 

Drive responds slowly immediately after power-up.

Run Computer Setup and increase the POST Delay in

 

Advanced > Power-On Options.

 

CD-ROM or DVD devices are not detected or driver is not loaded.

 

 

Cause

Solution

 

 

Drive is not connected properly or not properly configured.

See the documentation that came with the optional device.

 

 

Movie will not play in the DVD drive.

 

 

 

Cause

Solution

 

 

Movie may be regionalized for a different country.

See the documentation that came with the DVD drive.

 

 

Decoder software is not installed.

Install decoder software.

 

 

Damaged media.

Replace media.

 

 

Movie rating locked out by parental lock.

Use DVD software to remove parental lock.

 

 

Media installed upside down.

Reinstall media.

 

 

Cannot eject compact disc (tray-load unit).

Cause

Solution

Disc not properly seated in the drive.

Turn off the computer and insert a thin metal rod into the emergency eject hole and push firmly. Slowly pull the tray out from the drive until the tray is fully extended, then remove the disc.

178

Chapter 8 Troubleshooting Without Diagnostics