Shark SGP-4035E, SGP-3530E, SGP-3020, SGP-3030, SGP-3025 Operating Instructions, Manual Pressure

Page 8

WASHER

OPERATING INSTRUCTIONS

MANUAL PRESSURE

Oil Dipstick

Gas

Tank

OPERATOR’S

STEP 1: Check engine oil level. Oil level should be level with the bottom of the oil filler neck. Be sure the machine is level when checking the oil level. (Refer to the engine's operating manual included with machine.) We recommend that the oil be changed after the first 5 hours of use, then once every 50 hours. Note: Improper oil levels will cause low oil sensor to shut off engine. IMPORTANT! Do not run engine with high or low oil levels as this will cause engine damage.

STEP 2: Fill gas tank with unleaded gasoline. Do not use leaded gas- oline. Caution: Read warnings on pg. 4 and engine manual.

Cold

Water

Source

Garden

Hose

STEP 3: Connect garden hose to the

STEP 4: Trigger the spray gun to

cold water source and turn water on

eliminate trapped air then wait for a

completely. Never use hot water.

steady flow of water to emerge from

 

the spray nozzle.

Fuel

Valve

Choke

Lever

8

STEP 5: Rotate the fuel shut-off valve to the "On" po-

STEP 6: Pull the choke lever out to the "Choke" po-

sition. Slide the fuel valve lever to the "ON" position.

sition (on a warm engine, leave the choke lever in, in

When the engine is not in use, leave the fuel valve in

the run position). Push the choke lever to the "Closed"

the "OFF" position.

position. To restart a warm engine, leave the choke

 

lever in the "Open" position.

97-6132, 97-6151 • REV. 11/04

Image 8
Contents SGP Page Contents Important Safety IntroductionInstructions Owner/User ResponsibilityPressure Washer OPERATOR’S Manual Component Identification OPERATOR’S Manual PressureAssembly Instructions PressureOperating Instructions Manual PressureNozzles Cleaning Tips TechniquesRinsing RecommendationsShutting Down and CLEAN-UP Engine MaintenanceStorage After Extended StorageMaintenance and Service MaintenancePreventative Maintenance Electrode Setting Air AdjustmentRupture Disk FuelRemoval of Soot and Heating Coil Fuel Pressure AdjustmentCoil Reinstallation Troubleshooting Problem Possible Cause Solution LOW OperatingPressure Burner willProblem Possible Cause Solution Burner will not TemperatureMachine Smokes LOW WaterProblem Possible Cause Solution Detergent not On InstallationDrawing Pump RunningMaintenance Charts Maintenance ScheduleExploded View 3020, 3025 Models OPERATOR’S Manual Pressure Washer Exploded View 3030, 3530, 3530E, 4030E Models Exploded Views Parts List Description QTY01053 1089 Hose Barb, 1/4 Barb x 1/4 Pipe Control Panel Exploded View 3020, 3025 Models Control Panel 3030, 3530, 3530E, 4035E Models 3030, 3530, 3530E, 4035E Control Panel Parts List Item Part no Description QTY Hose & Spray GUN AssemblyHose & Spray GUN Parts List Downstream Injector Assembly Downstream Injector Parts List Hose Reel Option Hose Reel Parts List Specifications Beckett Burner SpecificationsPage Warranty