SERVICE ELECTRICAL
Clean Battery and Terminals
cCAUTION: Battery gas can explode, to avoid injury:
-Keep sparks and flames away from batteries. Use a flashlight to check battery electrolyte level.
-Never check battery charge by placing a metal object across the posts. Use a voltmeter or hydrometer.
-Always remove grounded
1.Turn ignition key off and lift hood.
2.Remove rubber
3.Disconnect BLACK
4.Disconnect RED (+) battery cable (C) and blue harness wire (D) and remove battery from mower.
5.Wash battery with solution of four tablespoons of baking soda to one gallon of water. Be careful not to get the soda solution into the cells.
6.Rinse the battery with clean water. Let dry.
7.Clean terminals and battery cable ends with wire brush until bright.
8.Apply petroleum jelly or silicone spray to terminal to prevent corrosion.
9.Reinstall battery. (See Removing and Installing the Battery in this section and Check and Connect the Battery in the Assembly section.)
C
B
D
A
M97159
Service Electrical - Page 50