Bass

How to Operate the C2300

changing it, use the TRIM SELECT Control or TRIM Push-button and select Balance.

The Intensity of the Low Frequencies in the music can be increased or decreased by using the Trim Select and Trim Adjust Controls. To make adjustment perform the follow- ing:

1.Rotate the Front Panel TRIM SELECT Control or press the TRIM Push-button on the Remote Control until “BASS __” appears on the Front Panel Alphanumeric Display.

2.Rotate the TRIM ADJUST Control or press the LEVEL

+/ - Push-buttons to increase or decrease the volumne level of the low frequencies. Refer to figure 17.

Figure 17

The Front Panel Display indicates the Bass changes in steps from -12dB to (+)12dB. After approximately 3 seconds the Alphanumeric Display returns to indicate the Source Selection and Volume Level.

TREBLE

The Intensity of the High Frequencies in the music can be

activate Tone Bypass perform the following:

1.Rotate the Front Panel TRIM SELECT Control or press the TRIM Push-button on the Remote Control until “TONE BYPASS” appears on the Front Panel Alpha- numeric Display.

2.Rotate the TRIM ADJUST Control or press the LEVEL

+/ - Push-buttons to activate the Tone Bypass or deac- tivate the Tone Bypass. Refer to figure 19.

Figure 19

After approximately 3 seconds the Alphanumeric Display returns to indicate the Source Selection and Volume Level.

TRIM LEVEL

The Trim Level adjustments al- lows for making fine adjustments to the previously performed Trim Level Adjustments in the Setup Section of this Owner’s Manual on page 11. To make fine adjustment to the currently selected Input Source perform the following:

increased or decreased by using the Trim Select and Trim Adjust Controls. To make adjustment perform the follow- ing:

1.Rotate the Front Panel TRIM SELECT Control or press the TRIM Push-button on the Remote Control until “TREBLE __” appears on the Front Panel Alphanu- meric Display.

2.Rotate the TRIM ADJUST Control or press the LEVEL

+/ - Push-buttons to increase or decrease the volume level of the high frequencies. Refer to figure 18.

Figure 18

The Front Panel Display indicates the Bass changes in steps from -12dB to (+)12dB. After approximately 3 sec- onds the Alphanumeric Display returns to the indicate the Source Selection and Volume Level.

TONE ENABLE/BYPASS

With the Tone Bypass active, the Bass and Treble Settings for the currently selected Input Source are electronicaly bypassed. When the Tone Bypass is switched Off the previous settings for Bass and Treble will be restored. To

1. Rotate the TRIM SELECT Control or press the TRIM Push-button on the Remote Control until “LEVEL _._” appears on the Front Panel Alphanumeric Display. Refer to figure 20.

2. Rotate the TRIM ADJUST Control or press the LEVEL + / - Push-buttons to adjust the volume level from -6dB to (+)6dB. Refer to figure 20.

After approximately 3 seconds the Alphanumeric Display returns to the indicate the Source Selection and Volume Level.

Figure 20

Figure 21