How to Operate the Tuner

The McIntosh C45 TM1 AM/FM Tuner Module incorpo- rates an advanced design AM/FM Tuner with many desir- able performance features to enhance your enjoyment of ra- dio broadcasts. There are three methods of tuning AM/FM Broadcast Stations using the Front Panel Tune Push-buttons and four methods using the Remote Control. These tuning methods include Manual, Automatic Station Seek, Auto- matic Preset Review, Preset Selection and Direct Preset Number Access.

Notes: FM Broadcast Band Indications are in Megahertz in the US and Canada, and change frequency in 200kHz steps. For FM stations in various locations other than the US stations change in 50kHz steps. AM Broadcast Band Indications are in Kilohertz and change frequency in 10kHz steps.

1.Select TUNER FM or TUNER AM with the Front Panel INPUT Control or the Remote Control TUNER Push-button followed by the AM or FM Push-button. Refer to figures 42 & 43.

2.For Manual Station Selection, press the Front Panel TUNE(TRIM LEVEL) UpS or DownT Push-button.

3.For Automatic Station Seek, press and release the CHANNEL UpS or DownT Push-button on the Re- mote Control, to select stations.

Note: The Front Panel TUNE(TRIM LEVEL) UpS or DownT Push-button may also be used, however the tunning mode in setup needs to be changed to the SEEK Mode from the default setting of Manual TUNE. Refer to page 16 for additional information.

4.For Automatic Preset Review, press and release the RE- VIEW Push-button on the Remote Control. The C45 will stop on the next assigned Preset Station for approximatley 5 seconds and then will proceed to the next Preset Station. When the desired station is heard press the REVIEW Push-button a second time to cancel the Preset Review Mode.

Note: There first must be stations entered into Preset Memory for the Review Mode to function. Refer to “How to Assign Tuner

Presets” for additional information.

5.For Preset Selection, press and release the NEXT XX or BACK WW Push-button on the Remote Control, to select a Preset Station.

Note: The Front Panel

TUNE (TRIM LEVEL) UpS or DownT Push-button may also be used, however the tunning mode in setup needs to be changed to the PRESET Mode from the default setting of Manual TUNE. Refer to page 16 for additional information.

6.For Direct Preset Number Access, select the Tuner

AM or FM Input using ei- ther the Front Panel IN- PUT Control or press the TUNER and AM or FM Push-buttons followed by the numbered push-button for the desired Preset.

Figure 43

Figure 42