McIntosh C45 owner manual Remote Control Selection

Setup, con’t

3.Press the TRIM LEVEL UPS or DownT Push-button until the display indicates “AUTOTONE ON”. Refer to figure 28.

Figure 28

4. Press the SETUP Push-button to exit the Setup Mode.

Remote Control Selection

The C45 will respond to two different sets of the Remote Control Codes. The Remote Control included with the C45 utilizes the NORMal McIntosh Control Codes. The Second Set of Control Codes the C45 will respond to is referred to as the ALTernate Codes. The ALTernate Codes are for when the C45 is used together with an other McIntosh Audio or Audio/Video Control Center or Preamplifier in the same system. This will prevent the Remote Control from affecting the operation of both units at the same time.

Note: If the ALT Remote Control Code is selected, the C45 will not respond using the supplied McIntosh Remote Control. See your McIntosh Dealer for additional information.

1.Press the SETUP Push-button to access the Setup Mode.

2.Press the TONE BYPASS (Menu) Push-button until “REMOTE NORM” appears on the Front Panel Alpha- numeric Display. Refer to figure 29.

Figure 29

3.Press the TRIM LEVEL UPS or DownT Push-but- ton until the display indicates “REMOTE ALT”. Refer to figure 30.

Figure 30

4. Press the SETUP Push-button to exit the Setup Mode.

20