North Star MTBSL owner manual Step Four Attach wheels to cart base

Page 11

Assembly (continued)

Step Four: Attach wheels to cart base

1.Slide axle into holes on bottom of cart base.

2.Slide the tires and wheel retainers onto the axle.

3.Tighten wheel retainers down with supplied hex wrench.

Cart base

Axle

Wood plank or spacer (Not included)

Wheel retainer

Tire

Step Five: Attach boom supports and boom bracket to cart base

1.Fasten the boom supports to the cart base with (4) 5/16 x ¾” carriage bolts and (4) 5/16 flange nuts. Tighten to 20 ft-lbs.

2.Fasten the boom bracket to the boom supports with (4) 5/16 x ¾” carriage bolts and (4) 5/16 flange nuts. Tighten to 20 ft-lbs.

5/16 Flange nut

Boom support

Cart base

			Boom bracket
		Boom support	5/16 x ¾”
	5/16 x ¾” Carriage bolt		5/16 x ¾”
	5/16 x ¾” Carriage bolt	5/16 Flange nut	Carriage bolt
		5/16 Flange nut	Carriage bolt

11

Image 11

Contents Mtbsl Hazard Signal Word Definitions Table of Contents Spraying Pesticides Intended UseChemical Application Safety Summary of Important Safety InformationDuring Assembly General Chemical SafetyTowing Safety Chemical accident proceduresDifferently with filled sprayer attached Unpacking Closely inspect all contents in the shipping cartonFollowing items are found in the manual bag Unpacking the Manual BagStep Three Attach the cart base to the sprayer AssemblyStep One Attach the tongue to the cart base Step Two Attach the hitch mount to the tongueStep Five Attach boom supports and boom bracket to cart base Step Four Attach wheels to cart baseStep Six Attach boom arms to the boom bracket Step Ten Attach drain cap to tank Step Seven Attach gun hose to spray gun and pumpStep Eight Attach hose guide to tank Step Nine Attach gun clips to tankStep Twelve Connect boom valve to boom nozzles Step Eleven Install boom valve to pumpStep Thirteen Attach sprayer to vehicle Step Fourteen Connect remote switch to vehicle batteryConnected to the battery Working condition Step Fifteen Check and test completed assemblyCheck and test completed assembly Check assemblyMachine Components General Chemical Safety Operation Important Safety InformationAfter Spraying Chemical Application SafetyBefore Spraying During SprayingTowing Safety Inhalation Inspect Inspect and test the sprayer thoroughly Repair Important safety rulesOperation Preparing the Sprayer for Each Use Spray because the wind is too strong Operation Using the SprayerStep One Assess wind conditions and clear work area Ensure tank is flushed of all chemicals from prior uses Fill the sprayer using the following stepsStep Two Fill the sprayer Fill tank Check drainBegin agitation if Review safetyStep Three Operate the sprayer Unfold one or both boom arms as required Adjust nozzleSqueeze trigger & To spray, squeeze the gun trigger Ensure uniform coverage Ensure correct spray patternLaunder Step Four Clean sprayer and decontaminate after useDrain tank DecontaminateAdd antifreeze StoragePreparing for storage Removing from storageBefore attempting to service the sprayer TroubleshootingAny Questions, Comments, Problems or Parts Orders SpecificationsPart# Description Model Qty Exploded View 28517/28518 Rev. LHeight Appendix a Broadcast Spray Calibration TablesApproximate flow from one nozzle Spray Pressure