North Star MTBSL owner manual Step Eleven Install boom valve to pump

Page 14

Assembly (continued)

Step Eleven: Install boom valve to pump

Install the boom valve with (2) hose clamps and (1) 14” hose. Follow hose clamp installation instructions below.

1.Attach one end of the 14” hose to the boom hose barb on the pump.

2.Attach the other end of the 14” hose to the boom valve.

Step Twelve: Connect boom valve to boom nozzles

Connect with (4) hose clamps, (1) 14” hose, and (1) 24” hose. Follow hose clamp installation instructions below.

1.Attach one end of the 14” hose to the boom valve.

2.Attach the other end of the 14” hose to the right nozzle fitting.

3.Attach one end of the 24” hose to the boom valve.

4.Attach the other end of the 24” hose to the left nozzle fitting.

Boom hose barb

Hose clamp

14” Hose

Hose clamp Boom valve

Right nozzle fitting

Hose clamp

14” Hose

Hose clamp

Hose clamp installation instructions

1.Slide hose clamp over the end of the hose

2.Push the hose onto the hose barb

3.Slide the hose clamp over the hose barb

4.Tighten the hose clamp

24” Hose

Left nozzle fitting

14

Image 14

Contents Mtbsl Hazard Signal Word Definitions Table of Contents Intended Use Spraying PesticidesGeneral Chemical Safety Summary of Important Safety InformationDuring Assembly Chemical Application SafetyChemical accident procedures Towing SafetyDifferently with filled sprayer attached Closely inspect all contents in the shipping carton UnpackingUnpacking the Manual Bag Following items are found in the manual bagStep Two Attach the hitch mount to the tongue AssemblyStep One Attach the tongue to the cart base Step Three Attach the cart base to the sprayerStep Four Attach wheels to cart base Step Five Attach boom supports and boom bracket to cart baseStep Six Attach boom arms to the boom bracket Step Nine Attach gun clips to tank Step Seven Attach gun hose to spray gun and pumpStep Eight Attach hose guide to tank Step Ten Attach drain cap to tankStep Eleven Install boom valve to pump Step Twelve Connect boom valve to boom nozzlesStep Fourteen Connect remote switch to vehicle battery Step Thirteen Attach sprayer to vehicleConnected to the battery Check assembly Step Fifteen Check and test completed assemblyCheck and test completed assembly Working conditionMachine Components Operation Important Safety Information General Chemical SafetyDuring Spraying Chemical Application SafetyBefore Spraying After SprayingTowing Safety Inhalation Inspect Inspect and test the sprayer thoroughly Repair Important safety rulesOperation Preparing the Sprayer for Each Use Spray because the wind is too strong Operation Using the SprayerStep One Assess wind conditions and clear work area Ensure tank is flushed of all chemicals from prior uses Fill the sprayer using the following stepsStep Two Fill the sprayer Check drain Fill tankBegin agitation if Review safetyStep Three Operate the sprayer Unfold one or both boom arms as required Adjust nozzleSqueeze trigger & To spray, squeeze the gun trigger Ensure correct spray pattern Ensure uniform coverageDecontaminate Step Four Clean sprayer and decontaminate after useDrain tank LaunderRemoving from storage StoragePreparing for storage Add antifreezeTroubleshooting Before attempting to service the sprayerSpecifications Any Questions, Comments, Problems or Parts OrdersExploded View 28517/28518 Rev. L Part# Description Model QtySpray Pressure Appendix a Broadcast Spray Calibration TablesApproximate flow from one nozzle Height