crystal.bk : cryst-2.fb4 Page 47 Monday, March 23, 1998 4:09 AM

Before Installing an IDE Device

Before Installing a SCSI Device

2How to Install Accessories Inside Your PC Workstation Installing Mass Storage Devices

Installing a Drive in a Front-Access Shelf

These instructions explain how to install a drive (such as a flexible disk drive, a CD-ROM drive, CD-RW drive, or a tape drive) in one of the front-access drive shelves. You should also refer to the manual supplied with the drive for any additional installation instructions.

Refer to the drive’s installation guide to see if you must set jumpers or if there is a special installation procedure to follow.

If you are installing a SCSI device, refer to the section “Before Installing a SCSI Hard Disk” on page 40 before using the following instructions.

1Disconnect the computer’s power cord and any telecommunications cable.

2Remove the computer’s cover (see page 25).

3Slide out the power supply to provide better access to the disk drive cables (see page 29).

4If installing a drive in a 5.25-inch wide shelf, remove the drive tray and put it in a safe place.

Remove the drive tray if installing a 5.25-inch drive

Mounting Rails

Slide the drive

into position

 

5Slide the drive into the shelf.

6Secure the drive in position using the screws provided with the drive.

47