crystal.bk : cryst-2.fb4 Page 54 Monday, March 23, 1998 4:09 AM

2 How to Install Accessories Inside Your PC Workstation Installing a Processor

7 The system board has two processor sockets and a VRM slot for each

 

processor. If you are changing the existing processor, remove it from

 

the socket by squeezing the tabs at the top and bottom of the

 

processor and gently pulling the processor away from the system

 

board. Then remove the VRM for the processor.

 

If you are installing a processor in the second socket, remove the

 

terminator.

NOTE

Installing a faster processor than the one supplied with your

 

PC Workstation will void the warranty.

 

8 Slide the new processor into the processor socket and push gently

 

until it snaps into place (the processor can only go in one way). If

 

you are installing a second processor, remove the card in the second

 

processor socket and slide the processor into the empty processor

 

socket (next to the existing processor).

 

VRM module

Processor

9Insert the VRM for the processor in the VRM socket.

10Replace the transparent section of the HP UltraFlow airflow guide covering the processor sockets.

11Slide the power supply back into the computer and tighten the four self-retaining screws.

12Turn the PC Workstation upright and replace the HP UltraFlow airflow guide.

13Reconnect the fan to the system board.

54