crystal.bk : cryst-1.fb4 Page 6 Monday, March 23, 1998 4:09 AM

NOTE

1 Setting Up and Using Your PC Workstation

Connecting an External SCSI Accessory

Connecting an External SCSI Accessory

Your PC Workstation is equipped with an UltraWide 16-bit SCSI connector for external SCSI devices.

When an external SCSI device is connected, the UltraWide 16-bit SCSI controller automatically switches to non-Ultra mode (maximum capacity of 20 MBs per second).

An external SCSI device is connected as follows:

1You should assign an unused SCSI address to the accessory. SCSI addresses range from 0 to 15 for wide 16-bit SCSI. The SCSI address 0 is reserved for the first SCSI hard disk drive and SCSI address 7 is reserved for SCSI controller (the default for narrow and wide SCSI devices).

Refer to the manual provided with the SCSI accessory for instructions on selecting a SCSI address.

You don’t need to set a SCSI address for Plug and Play SCSI devices (SCSI devices which support the SCAM protocol).

2Make sure the SCSI accessory is terminated correctly—either internally or by a terminating resistor (refer to the manual provided with the SCSI accessory).

Make sure the SCSI accessory is terminated

6