crystal.bk : cryst-4.fb4 Page 135 Monday, March 23, 1998 4:09 AM

4 Technical Information

Using the ArrayConfig Program

4The External 16/8-bit Symbios BIOS and the FastRAID BIOS cannot be loaded at the same time in BIOS setup. The Symbios BIOS should be disabled (from the Advanced/External and Internal Wide 16/8-bit SCSI window, disable Option ROM Scan). This may be fixed in a later version of the BIOS. Check the World Wide Web at the following site: http://www.hp.com/go/

kayaksupport/ to see if this has been corrected.

Consequence: you cannot boot from devices connected to the Symbios controller at the same time as Wide SCSI devices. It is, however, possible to manually switch from bootable SCSI devices, connected to the Symbios controller, to Wide SCSI devices.

5Ensure that you boot from the Windows NT diskettes provided and not from the CD-ROM. If you boot from the CD-ROM, the hard drive will not be found (problem relating to Windows NT).

6Ensure that the FastRAID/Array1000 drivers are installed. To install these drivers:

a Shut down your PC Workstation, remove the ARO-1130 adapter, and restart your system.

b Click the Start menu, point to Settings, and then click Control Panel.

c Double-click the SCSI Adapters icon, then the Drivers tab.

d Click Add, Have Disk..., and insert the Adaptec Array1000 driver diskette.

e When requested to enter the driver path, type A:\winnt and follow the installation instructions (the Windows NT 4.0 CD-ROM may be needed).

f Shut down your computer and re-install the FastRAID card.

135