Meridian America 551 Selecting a source, CD65, To switch on from standby, To select a source

Page 15

Selecting a source

	During normal use the integrated amplifier should be left in the	For example, if you select the		CD65
	standby state. This uses a negligible amount of electricity, but	CD input the display will show:		CD65
		CD input the display will show:
	ensures that the components of the integrated amplifier operate
	at maximum efficiency from the moment you start.	By default, the following six sources are available:
	If you are not going to use the integrated amplifier for a period of	Source	Label	Input
	several days you should switch the unit completely off, at the
		CD	CD	A2
	back panel, and disconnect it from the AC power supply.	CD	CD	A2
	back panel, and disconnect it from the AC power supply.
		Radio	RD	A3

To switch on from standby

●Press Source (front panel), or select a source by pressing the appropriate source key on the remote: eg CD.

If the 551 Integrated Amplifier is part of a Meridian system, it will automatically switch on any other unit in the system, such as the CD player.

To select a source

LP	LP	A1
TV	TV	A5
Tape1	T1	A4
Tape2	T2	A6

To switch to standby

●Press Off on the front panel or the remote.

Using the integrated

●Press Source (front panel) until the display shows the source you require, or press the appropriate source key on the remote: eg CD.

The display will show:

.

amplifier

The display shows the source, and volume setting.

If you have other Meridian 500 Series equipment connected to the integrated amplifier, these units will also switch to standby.

11

Image 15

Contents Meridian 551 Integrated Amplifier Preface Contents Setting up the integrated Amplifier25 Introduction Professional features Meridian 500 SeriesSeries communications 506 20-Bit CD Player Compact Disc Transport Sample configurations566 20-Bit Digital to Analogue Analogue Controller Converter 562V Multimedia Controller Specification Specification and accessoriesAvailable accessories Introduction Using the integrated amplifier Mute Front panelCD65 To switch on from standbyTo switch to standby Selecting a sourceCD55 Adjusting the volumeMute OffTo change the balance Changing the display and balance²O³ To change the displayTo copy a source to the tape output Recording a sourceCSrc CAttCustomising the integrated amplifier Choosing standard settings To select a standard settingType VCR2 Standard settingsConfiguring the sources To configure a sourceConf To change an option CD1CExamples of configuring the sources To change a source labelTo change the audio input for a source To set up a system with two CD players Programming levels GainTo balance input levels LP MM LP MC 12dBPA=1 Specifying information about your systemAuto SA=1Setting up the integrated amplifier Radio interference Before connecting powerUnpacking To position the integrated amplifierConnecting the integrated amplifier Back panelAudio connections Con To connect to a tape recorderTo connect to other Meridian 500 Series equipment To connect to A500 Loudspeakers NConTo connect to Meridian 600 or 200 Series equipment Sound has cut out and the display shows Hot TroubleshootingNo lights are displayed when switching on Sound has cut out and the display shows DCThere is hum on other inputs There is hum on the LP inputTo clean the audio connections MaintenanceCleaning To clean the case, display panel, and keypadService and guarantee ServiceGuarantee Index CleaningSound restoring Index