Meridian America 551 manual NCon, To connect to A500 Loudspeakers

Page 33

This is the unit that will respond to the remote.

	All the other units will be configured	NCon
	as non-controllers, and display:	NCon
	as non-controllers, and display:

Your system is now set up and ready for use.

●If, for any reason, the automatic setup does not give the configuration you want, restore the default operation by selecting Type 1 as described in To connect to Meridian 600 or 200 Series equipment, page 30.

●If you want to change the automatic setup configuration refer to the Meridian 500 Series User Guide.

Note: Do not, under any circumstances, connect any equipment other than Meridian 500, 600, or 200 Series to the socket marked COMMS on the back of the integrated amplifier.

To connect to A500 Loudspeakers

A500 Loudspeaker

A500 Loudspeaker

551 Integrated Amplifier

●Use the links provided to bridge the BASS/MID and TWEETER terminals on the back of each loudspeaker.

●Connect one of each pair of the red and black terminals on the back panel of the 551 Integrated Amplifier to the red and black terminals on the A500 Loudspeakers.

Setting up the integrated amplifier

29

Image 33

Contents Meridian 551 Integrated Amplifier Preface Contents Setting up the integrated Amplifier25 Introduction Professional features Meridian 500 SeriesSeries communications 506 20-Bit CD Player Compact Disc Transport Sample configurations566 20-Bit Digital to Analogue Analogue Controller Converter 562V Multimedia Controller Specification Specification and accessoriesAvailable accessories Introduction Using the integrated amplifier Mute Front panelTo switch to standby To switch on from standbySelecting a source CD65Mute Adjusting the volumeOff CD55²O³ Changing the display and balanceTo change the display To change the balanceCSrc Recording a sourceCAtt To copy a source to the tape outputCustomising the integrated amplifier Choosing standard settings To select a standard settingType VCR2 Standard settingsConfiguring the sources To configure a sourceConf To change an option CD1CExamples of configuring the sources To change a source labelTo change the audio input for a source To set up a system with two CD players Programming levels GainTo balance input levels LP MM LP MC 12dBAuto Specifying information about your systemSA=1 PA=1Setting up the integrated amplifier Unpacking Before connecting powerTo position the integrated amplifier Radio interferenceConnecting the integrated amplifier Back panelAudio connections Con To connect to a tape recorderTo connect to other Meridian 500 Series equipment To connect to A500 Loudspeakers NConTo connect to Meridian 600 or 200 Series equipment No lights are displayed when switching on TroubleshootingSound has cut out and the display shows DC Sound has cut out and the display shows HotThere is hum on other inputs There is hum on the LP inputCleaning MaintenanceTo clean the case, display panel, and keypad To clean the audio connectionsService and guarantee ServiceGuarantee Index CleaningSound restoring Index