Meridian America 551 manual To connect to Meridian 600 or 200 Series equipment

Page 34

Setting up the integrated amplifier

To connect to Meridian 600 or 200 Series equipment

If your system includes any Meridian 600 or 200 Series units, with 600 COMMS or 200 COMMS sockets, you should set all the 500 Series units to 200 COMMS operation using the following procedure:

●Turn off the integrated amplifier, using the power switch on the back panel.

●Turn on the power again while holding down the Off key on the front panel.

	The display will show	Ty 1
	the current Type setting:	Ty 1
	the current Type setting:

●Press A or V on the front panel to change the Type setting.

If your system includes a Meridian CD player select Type 2; otherwise select Type 6.

	For example, if you select	Ty 2
	Type 2 the display will show:	Ty 2
	Type 2 the display will show:

●Switch the power off and on again to restore the integrated amplifier to normal operation.

●To return to 500 COMMS operation repeat the above procedure, and select Type 1, 3, 4, or 5. For more information see Choosing standard settings, page 16.

30

Image 34

Contents Meridian 551 Integrated Amplifier Preface Contents Setting up the integrated Amplifier25 Introduction Meridian 500 Series Professional featuresSeries communications Sample configurations 506 20-Bit CD Player Compact Disc Transport566 20-Bit Digital to Analogue Analogue Controller Converter 562V Multimedia Controller Specification and accessories SpecificationAvailable accessories Introduction Using the integrated amplifier Front panel MuteSelecting a source To switch on from standbyTo switch to standby CD65Off Adjusting the volumeMute CD55To change the display Changing the display and balance²O³ To change the balanceCAtt Recording a sourceCSrc To copy a source to the tape outputCustomising the integrated amplifier To select a standard setting Choosing standard settingsType Standard settings VCR2To configure a source Configuring the sourcesConf CD1C To change an optionTo change a source label Examples of configuring the sourcesTo change the audio input for a source To set up a system with two CD players Gain Programming levelsTo balance input levels 12dB LP MM LP MCSA=1 Specifying information about your systemAuto PA=1Setting up the integrated amplifier To position the integrated amplifier Before connecting powerUnpacking Radio interferenceBack panel Connecting the integrated amplifierAudio connections To connect to a tape recorder ConTo connect to other Meridian 500 Series equipment NCon To connect to A500 LoudspeakersTo connect to Meridian 600 or 200 Series equipment Sound has cut out and the display shows DC TroubleshootingNo lights are displayed when switching on Sound has cut out and the display shows HotThere is hum on the LP input There is hum on other inputsTo clean the case, display panel, and keypad MaintenanceCleaning To clean the audio connectionsService Service and guaranteeGuarantee Cleaning IndexSound restoring Index