Meridian America 551 manual CD1C, To change an option

Page 23

To change an option

●Press A or V to step between the alternative values for the option.

When you have finished programming sources:

●Switch off at the back panel, and then switch on again to restore normal operation.

	Option	Initial value	Alternative values	Explanation
	Label		CD, RD, LP, etc.	See page 20.
	Label	CDCD	CD, RD, LP, etc.	See page 20.
		CDCD
	Audio input		A1 – A6, or LV.	Choose A1 to A6 to specify the input, or LV to use

		CDA2
		CDA2		the last valid input.
				the last valid input.
	Comms type		1C – 8C, or NC.	Choose 1C for a Meridian CD player, 2C for a
	Comms type	CD1C	1C – 8C, or NC.	Choose 1C for a Meridian CD player, 2C for a
		CD1C		Meridian FM Tuner, or NC otherwise.
				Meridian FM Tuner, or NC otherwise.
	Address		1A – 8A.	Allows you to have up to eight of each source type.
	Address	CD1A	1A – 8A.	Allows you to have up to eight of each source type.
		CD1A

Customising the integrated amplifier

19

Image 23

Contents Meridian 551 Integrated Amplifier Preface Contents Setting up the integrated Amplifier25 Introduction Series communications Professional featuresMeridian 500 Series 506 20-Bit CD Player Compact Disc Transport Sample configurations566 20-Bit Digital to Analogue Analogue Controller Converter 562V Multimedia Controller Specification Specification and accessoriesAvailable accessories Introduction Using the integrated amplifier Mute Front panelCD65 To switch on from standbyTo switch to standby Selecting a sourceCD55 Adjusting the volumeMute OffTo change the balance Changing the display and balance²O³ To change the displayTo copy a source to the tape output Recording a sourceCSrc CAttCustomising the integrated amplifier Type Choosing standard settingsTo select a standard setting VCR2 Standard settingsConf Configuring the sourcesTo configure a source To change an option CD1CTo change the audio input for a source Examples of configuring the sourcesTo change a source label To set up a system with two CD players To balance input levels Programming levelsGain LP MM LP MC 12dBPA=1 Specifying information about your systemAuto SA=1Setting up the integrated amplifier Radio interference Before connecting powerUnpacking To position the integrated amplifierAudio connections Connecting the integrated amplifierBack panel To connect to other Meridian 500 Series equipment ConTo connect to a tape recorder To connect to A500 Loudspeakers NConTo connect to Meridian 600 or 200 Series equipment Sound has cut out and the display shows Hot TroubleshootingNo lights are displayed when switching on Sound has cut out and the display shows DCThere is hum on other inputs There is hum on the LP inputTo clean the audio connections MaintenanceCleaning To clean the case, display panel, and keypadGuarantee Service and guaranteeService Index CleaningSound restoring Index