Meridian America 588 manual Switching on and off, To switch on from standby, To switch to standby

Page 14

Switching on and off

During normal use the compact disc player should be left in the standby state. This uses a negligible amount of electricity, but ensures that the components operate at maximum efficiency from the moment you start playing a disc.

If you are not going to use the compact disc player for a period of several days you should switch the unit completely off, at the back panel, and disconnect it from the AC power supply.

To switch on from standby

Press Open, *, or >(front panel), or select a source on the remote.

Switch on any other equipment connected to the compact disc player which is not part of the Meridian 500 Series.

Press Open (front panel), Function * (remote), or >to close the tray.

To switch to standby

Using the

The display will flash for a few seconds. The compact disc player is then ready for use.

Press Off.

The display will show:

.

compact

To insert a disc

Press Open (front panel) or Function * (remote) to open the tray.

Place your disc, label side up, in the tray as shown opposite.

If you have other Meridian 500 Series equipment connected to the compact disc player, these units will also switch to standby.

If a disc is currently playing, switching to standby will stop the disc, and the disc can safely be left in the unit.

disc player

9

Image 14
Contents Meridian 588 Compact Disc Player Meridian Compact Disc Player User Guide Sales and service in the UK Contents Configuring the compact Disc player TroubleshootingIntroduction Series communications Professional featuresMeridian 500 Series Sample configurations Analogue controller Digital Control UnitMeridian Digital Music System Specification and accessories SpecificationAvailable accessories Using the compact disc player Front panel To switch to standby Switching on and offTo switch on from standby To insert a discTo play starting from a particular track Playing a discTo move to the next track To play the discTo stop play Stopping and pausing playTo continue after pausing To pause playRepeating play To cancel A-B repeatTo cancel the repeat function To repeat between two positionsTo choose a track to programme Programming a selectionTo programme by storing the tracks you want to play To clear a programme To programme by clearing the tracks you do not want to playTo remove a track from a selection To add a track to a selectionScanning a disc Disc information and scanningTo change the display To scan through a discTo change the phase setting Changing the absolute phaseTo display the phase setting Setting up the compact disc player Unpacking Radio interferenceTo avoid interference Safety warningsPositioning the compact disc player To avoid overheatingAudio connections Connecting the compact disc playerBack panel Communications connections CommsTo connect to other Meridian 500 Series equipment Up the compact disc playerConnecting audio To connect to Meridian DSP loudspeakers Configuring the compact disc player Choosing standard settings To restore the standard settingsTo configure the compact disc player Specifying information about your systemConfiguring the compact disc player Troubleshooting There is no sound when playing a disc TroubleshootingNo lights are displayed when switching on Display shows No disc when attempting to play a disc Single key press on the remote causes multiple entriesCreating MP3 discs To clean the case, display panel, and keypad MaintenanceCleaning To clean the audio connectionsGuarantee Service and guaranteeService Index Continuing play Digital output 21 disc informationPhase