Meridian America 588 manual Troubleshooting, No lights are displayed when switching on

Page 35

Troubleshooting

Troubleshooting

30

No lights are displayed when switching on

❍Check that your AC power supply is connected correctly.

❍Check that the ON OFF switch on the back panel is in the ON position.

❍Check that the fuse on the compact disc player back panel and the fuse in the unit’s power plug have not blown; see To change the mains fuse, page 33.

There is no sound when playing a disc

❍Check that your preamplifier is switched on, and the volume is at an appropriate level.

❍Check that the compact disc player is connected correctly to the other components of your system; see Connecting the compact disc player, page 20.

❍Check that the correct source has been selected on your preamplifier.

❍Check that the compact disc player is not paused.

❍Try playing another disc. If this disc works, check the problem disc for signs of dirt or damage.

There is interference on the radio and/ or television when the compact disc player is switched on

Before following the steps below, ensure all units are switched off.

If this equipment does cause or suffer from interference to/from radio or television reception then the following measures should be tried:

❍Reorient the receiving aerial (or antenna) or route the antenna cable of the receiver as far as possible from the 588 Compact Disc Player and its cabling.

❍Ensure that the receiver uses well-screened antenna cable.

❍Relocate the receiver with respect to the compact disc player.

❍Connect the receiver and this product to different AC outlets.

Image 35

Contents Meridian 588 Compact Disc Player Meridian Compact Disc Player User Guide Sales and service in the UK Contents Troubleshooting Configuring the compact Disc playerIntroduction Series communications Professional featuresMeridian 500 Series Analogue controller Digital Control Unit Sample configurationsMeridian Digital Music System Specification Specification and accessoriesAvailable accessories Using the compact disc player Front panel To insert a disc Switching on and offTo switch on from standby To switch to standbyTo play the disc Playing a discTo move to the next track To play starting from a particular trackTo pause play Stopping and pausing playTo continue after pausing To stop playTo repeat between two positions To cancel A-B repeatTo cancel the repeat function Repeating playTo choose a track to programme Programming a selectionTo programme by storing the tracks you want to play To add a track to a selection To programme by clearing the tracks you do not want to playTo remove a track from a selection To clear a programmeTo scan through a disc Disc information and scanningTo change the display Scanning a discTo change the phase setting Changing the absolute phaseTo display the phase setting Setting up the compact disc player Radio interference UnpackingTo avoid overheating Safety warningsPositioning the compact disc player To avoid interferenceAudio connections Connecting the compact disc playerBack panel Comms Communications connectionsUp the compact disc player To connect to other Meridian 500 Series equipmentConnecting audio To connect to Meridian DSP loudspeakers Configuring the compact disc player To restore the standard settings Choosing standard settingsSpecifying information about your system To configure the compact disc playerConfiguring the compact disc player Troubleshooting There is no sound when playing a disc TroubleshootingNo lights are displayed when switching on Single key press on the remote causes multiple entries Display shows No disc when attempting to play a discCreating MP3 discs To clean the audio connections MaintenanceCleaning To clean the case, display panel, and keypadGuarantee Service and guaranteeService Continuing play Digital output 21 disc information IndexPhase