Marathon F200060 manual LOW Byte Input Event, Upper Byte Load Line, LOW Byte Cold Junction Trim

				BLOCK 0
HEX	DEC	PARAMETER	DESCRIPTION		READ/WRITE
			DEFAULT = 150
05	5	EVENT	LOW BYTE – INPUT EVENT		READ/WRITE
		LDLN	CONFIGURATION
			Bits 0 – 3
			0000	= None
			0001	= Auto Mode Selected
			0010	= Remote Setpoint Selected
			0011	= Acknowledge alarms
			0100	= Timer Hold
			0101	= Timer End
			0110	= Timer Start
			0111	= Start probe test
			1000	= Process hold
			Bits 4 – 7 not used.
			UPPER BYTE – LOAD LINE
06	6	CJTRM	LOW BYTE – COLD JUNCTION TRIM
		HADR	COLD JUNCTION TRIM (unsigned integer)
			RANGE = –128 TO +127 WHERE
			1 COUNT = 1 DEG (C or F) and –128 = 65408
			HIGH BYTE – HOST ADDRESS
			BITS 0-7
			RANGE = 0 – 255
07	7	SPARE	SPARE
08	8	CONFIG0	Input Configuration		READ/WRITE
			BITS 0-3 TC Input TYPE
			0000	= B (DEFAULT)
			0001	= E
			0010	= J
			0011	= K
			0100	= N
			0101	= R
			0110	= S
			0111	= T
			1000	= SPARE
			1001	= SPARE
			1010	= SPARE
			1011	= SPARE
			1100	= SPARE
			1101	= SPARE
			1110	= SPARE
			1111	= SPARE
			BIT 4 = SPARE
			BIT 5 0 = NO CJ APPLIED, 1 = CJ APPLIED
			BIT 6 0 = °F, 1 = °C
			BIT 7 0 = 60HZ FILTER
			BIT 8 – 11 Millivolt Input TYPE
			0000	= LINEAR (DEFAULT)
			All other bit combinations are spare
			BITS 12 – 15 are spare
09	9	CONFIG2	SETUP VALUES

Page 13 of 23

11/14/2006 Rev. 14