Multiquip GAC-9.7HZ General Inspection Prior to Operation Ground Power Tools, Extension Cable

INSPECTION/SETUP

General Inspection Prior to Operation Ground Power Tools

When using power tools or electrical equipment requireing AC power from the generator, make sure power tool cord has a ground pin or is double insulated as shown in Figure 5.

NOTICE

Double-insulated power tools and small appliances have specially insulated housings that eliminate the need for a ground. These types of double-insulated power cords are designed so that no part of the device will be electrically live even if the internal insulation fails.

Extension Cable

When electric power is to be provided to various tools or loads at some distance from the generator, extension cords are normally used. Cables should be sized to allow for distance in length and amperage so that the voltage drop between the generator and point of use (load) is held to a minimum. Use the cable selection chart (Table 3) as a guide for selecting proper cable size.

DANGER

NEVER use power tools or equipment that do not have a ground capability, the possibility exists of electrocution, electrical shock or burn, which can cause severe bodily harm or even DEATH!

	Circuit Breakers
Figure 5. Ground Pin	ALWAYS place the main, auxiliary and GFCI circuit
	breakers in the OFF position prior to starting the engine.

Table 3. Cable Selection (60 Hz, Single Phase Operation)

Current In	Load In Watts			Maximum Allowable Cable Length
Amperes	120 Volts	240 Volts	#10 Wire		#12 Wire	#14 Wire	#16 Wire
2.5	300	600	1000 ft.		600 ft.	375 ft.	250 ft.
5	600	1200	500 ft.		300 ft.	200 ft.	125 ft.
7.5	900	1800	350 ft.		200 ft.	125 ft.	100 ft.
10	1200	2400	250 ft.		150 ft.	100 ft.
15	1800	3600	150 ft.		100 ft.	65 ft.
20	2400	4800	125 ft.		75 ft.	50 ft.

CAUTION: Equipment damage can result from low voltage.

GAC9.7HZ 60 hz GENERATOR • operation and parts manual — rev. #2 (03/31/10) — page 19