Multiquip GAC-6HZR Outdoor Installation, Indoor Installation, Placement, Generator Grounding

Page 15

installation

Outdoor Installation

If possible install the generator in a area that is free of debris, bystanders, and overhead obstructions. Make sure the generator is on secure level ground so that it cannot slide or shift around.

The installation site must be relatively free from moisture and dust. All electrical equipment should be protected from excessive moisture. Failure to do will result in deterioration of the insulation and will result in short circuits and grounding.

Foreign materials such as dust, sand, lint and abrasive materials have a tendency to cause excessive wear to engine and alternator parts.

WARNING

Pay close attention to ventilation when operating the generator inside tunnels and caves. The engine exhaust contains noxious elements. Engine exhaust must be routed to a ventilated area

Indoor Installation

Exhaust gases from gas engines are extremely poisonous. Whenever an engine is installed indoors the exhaust fumes must be vented to the outside. The engine should be installed at least two feet from any outside wall. Using an exhaust pipe which is too long or too small can cause excessive back pressure which will cause the engine to heat excessively and possibly burn the valves.

placement

The generator should always be placed on a flat level surface when it is running. DO NOT place the generator on slopes, the possibility exists that the generator could slide.

DANGER

An electric shock is apt to happen when vibrators are used. Pay close attention to handling when operating vibrators and always use rubber boots and gloves to insulate the body from a short circuit.

Generator Grounding

To guard against electrical shock and possible damage to the equipment, it is important to provide a good EARTH ground.

Article 250 (Grounding) of the National Electrical Code (NEC) provides guide lines for proper grounding and specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

NEC articles 250-64(b) and 250-66 set the following grounding requirements:

1.Use one of the following wire types to connect the generator to earth ground.

a.Copper - 10 AWG (5.3 mm2) or larger.

b.Aluminum - 8 AWG (8.4 mm2) or larger.

2.When grounding the generator (Figure 2) connect the ground cable between the lock washer and the nut on the generator and tighten the nut fully. Connect the other end of the ground cable to earth ground.

3.NEC article 250-52(c) specifies that the earth ground rod should be buried a minimum of 8 ft. into the ground.

NOTICE

When connecting the generator to any buildings electrical system ALWAYS consult with a licensed electrician.

GAC6HZR 60 hz GENERATOR • operation and parts manual — rev. #1 (03/31/10) — page 15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Model gaC-6HZR GAC6HZR Portable 60 Hz Generator Table of ContentsChoose from three easy options SaFeTY messages Safety InformationGeNeRaTOR saFeTY GeNeRal saFeTYFuel saFeTY ENgiNe saFeTYBaTTeRY saFeTY eleCTRiC sTaRT ONlY EleCTRiCal saFeTYPower Cord/Cable safety Grounding safetyENviRONmeNTal saFeTY TRaNspORTiNg saFeTYPage Specifications Generator Specifications gENERATOREffects of Altitude and Heat Specifications engine18.9 480 MM DimensionsPage Connecting the Ground InstallationGenerator Grounding Outdoor InstallationIndoor Installation PlacementGeneral information GeneratorControl Box Honda Components generatorFuel Tank Fuel tank capacity is 5 gallons 19 liters General Inspection Prior to Operation Ground Power Tools Extension CableMain/GFCI Circuit Breakers Before Starting Engine Oil CheckFuel Check Operation Before Starting the EngineStarting the Engine Place main circuit breaker in the on position Operation/shutdown Stopping the Engine Normal ShutdownEmergency Shutdown Generator Storage Preparation for long term storageFirst Every MaintenanceWeekly MaintenanceEngine Air Cleaner DailySW2 Generator wiring digramEngine Troubleshooting Troubleshooting EngineWeak in power Water in fuel system? Troubleshooting Generator Page Explanation of Code in Remarks Column Suggested Spare Parts 5561058 and below GAC6HZR- nameplate and decalS AssyPart Name GAC6HZR- Generator Assy SET BOLT, Rotor RECTIFIER, D3SB80Surge Absorber BEARING, 6304 2RU NycmGAC6HZR- Control BOX Assy Slow Down Unit Idle Control SwitchOperation Switch Control BOXGAC6HZR- Muffler Assy Muffler BOLT, HEX HeadBracket GAC6HZR- Pipe Frame Assy Stopper Pipe FrameBase Rubber SuspensionHonda GX340K1/U1EDN2 AIR Cleaner Assy STAY, AIR Cleaner ELEMENT, AIR CleanerSEPARATOR, AIR Cleaner CASE, AIR CleanerHonda GX340K1/U1EDN2 Engine Camshaft Assy ARM, Valve Rocker SPRING, Weight ReturnIncludes ITEMS/W$ ROD, PushHonda GX340K1/U1EDN2 Engine Carburetor Assy Chamber SET, Float Gasket SETValve SET, Float Float SETHonda GX340K1/U1EDN2 Engine Carburetor Assy LEVER, Choke GASKET, AIR CleanerCLIP, Wire Harness STAY, SolenoidHonda GX340K1/U1EDN2 Engine Control Assy SPRING, Governor SPRING, Control AdjustingARM, Governor ROD, GovernorHonda GX340K1/U1EDN2 Engine Crankcase Cover Assy GASKET, Case Cover WEIGHT, GovernorHOLDER, Governor Weight PIN, Governor WeightHonda GX340K1/U1EDN2 Engine Crankshaft Assy WEIGHT, Balancer Honda GX340K1/U1EDN2 Engine Cylinder Barrel Assy BOLT, Drain Plug Switch ASSY., OIL LevelWIRE, Ground SHAFT, Governor ARMHonda GX340K1/U1EDN2 Engine Cylinder Head Assy COVER, Head GUIDE, Valve OS OptionalCLIP, Valve Guide GASKET, Cylinder HeadHonda GX340K1/U1EDN2 Engine FAN Assy COVER, FAN *NH1* Black ShroudGROMMET, Drain Hole Honda GX340K1/U1EDN2 Engine Flywheel Assy FAN, Cooling PULLEY, StarterFlywheel COMP., Lamp Honda GX340K1/U1EDN2 Engine Ignition Coil Assy HOLDER, Stop Switch Wire CLAMP, WireGROMMET, Wire WIRE, Stop Switch 470MMHonda GX340K1/U1EDN2 Engine Piston Assy PIN, Piston BOLT, Connecting RODRing SET, Piston STD Piston STDHonda GX340K1/U1EDN2 Engine Recoil Starter Assy SPRING, Starter Return PULLEY, Recoil StarterRATCHET, Starter SPRING, FrictionHonda GX340K1/U1EDN2 Engine Solenoid Assy SPRING, Choke Return LEVER, ThrottleSolenoid Assy Honda GX340K1/U1EDN2 Engine Fuel Cock Assy CUP, Fuel Strainer PACKING, Fuel Strainer CUPRing Filter CUPHonda GX340K1/U1EDN2- Engine Decals Assy Emblem GX240 Honda DECAL, AIR CleanerDECAL, Choke DECAL, Choke GrayHonda GX340K1/U1EDN2 Engine Tool KIT BAG Tool Wrench COMP. Spark PlugHANDLE, BOX Wrench SapnnerFReigHT pOliCY Terms and Conditions of Sale PartsPage HERE’S HOW to GET Help

GAC-6HZR specifications

The Multiquip GAC-6HZR is a versatile and powerful gasoline generator designed for a wide range of applications, including construction sites, events, and emergency backup power. Built with reliability and performance in mind, this generator is an excellent choice for users seeking a robust power solution.

One of the main features of the GAC-6HZR is its impressive output capacity. With a maximum power output of 6,000 watts and a rated output of 5,500 watts, this generator can handle multiple tools and appliances simultaneously, making it an ideal choice for contractors and outdoor enthusiasts alike. The addition of a reliable Honda GX390 engine ensures optimal performance and fuel efficiency, allowing for extended run times between refueling.

The GAC-6HZR is equipped with an easy-to-read control panel that features multiple 120V and 240V outlets, a circuit breaker, and a gas gauge, providing users with everything they need to manage their power needs efficiently. The inclusion of a 12V DC outlet also allows for charging batteries, further enhancing its usability across different applications.

Safety considerations are paramount in the design of the GAC-6HZR. The generator includes a low-oil shutdown feature that automatically turns off the engine when oil levels drop to a dangerous level, preventing damage and extending the unit's lifespan. Additionally, its sturdy steel frame construction provides durability and protection against harsh environments.

The GAC-6HZR also integrates advanced technologies to enhance its performance and user experience. Its digital ignition system ensures easier starts in various conditions, while its noise-reducing design keeps operation quiet enough for use in residential areas or during events. Furthermore, the generator's compact and portable design, featuring ergonomically designed handles, allows for easy transportation and maneuvering on job sites or around the home.

In conclusion, the Multiquip GAC-6HZR is a powerful and reliable generator that is well-equipped to meet the demands of users in various fields. With its high output, advanced safety features, and user-friendly design, it stands out as a dependable power solution for anyone in need of portable electricity. Whether used for construction, events, or emergency power supply, the GAC-6HZR is designed to deliver exceptional performance and reliability.
Top Page Image Contents