OUTPUT TERMINAL PANEL CONNECTIONS
UVWO TERMINAL OUTPUT VOLTAGES
Various output voltages can be obtained using the UVWO output terminal lugs. The voltages at the terminals are dependent on the placement of the jumpers plates (6) on the Voltage
Remember the voltage
3Ø-240V UVWO Terminal Output Voltages
1.Jumper the voltage
3.Turn the voltage regulator knob (Figure 20) clockwise to increase voltage output, turn counterclockwise to decrease voltage output. Use voltage regulator adjustment knob whenever fi ne tuning of the output voltage is required
Figure 20. Voltage Regulator Knob
1Ø-240V UVWO Terminal Output Voltages
1.Make sure the voltage
2.Connect the load wires to the UVWO terminals as shown in Figure 21.
Figure 18. Voltage Change-Over Board 240V
Configuration
2.Connect the load wires to the UVWO terminals as shown in Figure 19.
Figure 21. UVWO Terminal Lugs 1Ø-240V
Connections
1Ø-120V UVWO Terminal Output Voltages
1.Make sure the voltage
2.Adjust voltage regulator knob (Figure 20) for an output of 208V to obtain 120V at the UVWO terminals.
3.Connect the load wires to the UVWO terminals as shown in Figure 22.
Figure 19. UVWO Terminal Lugs
Figure 22. UVWO Terminal Lugs 1Ø-120V
Connections
PAGE 28 — DCA250SSI/DCA250SSIU GENERATOR • OPERATION AND PARTS MANUAL — REV. #0 (01/12/11)