Multiquip dca25ssiu3 Check Oil Level, Replacing Oil Filter, Radiator Cleaning, Generator Storage

Page 37

Maintenance

Check Oil Level

Check the crankcase oil level prior to each use, or when the fuel tank is filled. Insufficient oil may cause severe damage to the engine. Make sure the generator is level. The oil level must be between the two notches on the dipstick as shown in Figure 28.

Replacing Oil Filter

„„Remove the old oil filter.

„„Apply a film of oil to the gasket on the new oil filter. „„Install the new oil filter.

„„After the oil cartridge has been replaced, the engine oil will drop slightly. Run the engine for a while and check for leaks before adding more oil if needed. Clean excessive oil from engine.

Flushing Out Radiator and Replacing Coolant

„„Open both cocks located at the crankcase side and at the lower part of the radiator and drain coolant. Open the radiator cap while draining. Remove the overflow tank and drain.

„„Check hoses for softening and kinks. Check clamps for signs of leakage.

„„Tighten both cocks and replace the overflow tank.

„„Replace with coolant as recommended by the engine manufacturer.

„„Close radiator cap tightly.

„„Flush the radiator by running clean tap water through radiator until signs of rust and dirt are removed. DO NOT clean radiator core with any objects, such as a screwdriver.

WARNING

Allow engine to cool when flushing out radiator. Flushing the radiator while hot could cause serious burns from water or steam.

Radiator Cleaning

The radiator (Figure 54) should be sprayed (cleaned) with a high pressure washer when excessive amounts of dirt and debris have accumulated on the cooling fins or tube. When using a high pressure washer, stand at least 5 feet (1.5 meters) away from the radiator to prevent damage to the fins and tube.

Figure 54. Radiator Cleaning

Generator Storage

For long term storage of the generator the following is recommended:

„„Drain the fuel tank completely.Treat with a fuel stabilizer if necessary.

„„Completely drain the oil from the crankcase and refill if necessary with fresh oil.

„„Clean the entire generator, internal and external.

„„Cover the generating set and store in a clean, dry place.

„„Disconnect the battery.

„„Make sure engine coolant is at proper level.

„„If generator is mounted on a trailer, jack trailer up and place on blocks so tires do not touch the ground or block and completely remove the tires.

DCA25SSIU3 (with MLT25 series) • operation and parts manual — rev. #1 (01/24/13) — page 37

Page 36 Page 38
Image 37
Page 36 Page 38
Contents Model dca25ssiu3 Parts List NO. M1870301004CProposition 65 warning Administrator Reporting Safety DefectsDCA25SSIU3 Generator Table of ContentsChoose from three easy options SaFeTY MeSSageS Safety InformationSaFeTY SYMBoLS GeneraTor SaFeTY GeneraL SaFeTYRestricted. If the air fl ow is EngIne SaFeTYIf operating in speed ranges above the maximum allowable TowIng SaFeTY FUeL SaFeTY„ never use fuel as a cleaning agent From fuel vapors or if fuel is spilled on a hot engineGrounding Safety ELeCTrICaL SaFeTYPower Cord/Cable Safety DeathEnvIronMenTaL SaFeTY BaTTerY SaFeTY240/120 SpecificationsModel Isuzu BV 4LE2 Tier Dimensions DimensionsTypical Generator Grounding Application InstallationIndoor Installation Outdoor InstallationMounting Generator GroundingGeneral Information Item no Major ComponentsGenerator Control Panel Generator Control PanelEngine Operating Panel Terminal legs O and Ground are considered bonded grounds Output Terminal FamiliarizationOutput Terminal Panel is provided with the following VAC Gfci Receptacles Removing the Plastic Face Plate Hard Wire Hookup PanelOver Current Relay Connecting LoadsThree Phase Load Single Phase LoadLoad Application Type of LoadVoltage Selector Switch Locking Button Voltage Selector SwitchGenerator Output Voltages Generator AmperageGenerator OUTPUTS/gauge reading How to Read the ac ammeter and ac voltage gaugesAC Voltmeter Gauge Reading AC Ammeter Gauge Reading3Ø-240/139 Uvwo Terminal Output Voltages Uvwo Terminal Output Voltages3Ø-208V/1Ø-120V Uvwo Terminal Output Voltages 1Ø-240/120V Uvwo Terminal Output Voltages 3Ø-480/277V Uvwo Terminal Output VoltagesCircuit Breakers Inspection/SETUPLubrication Oil Fuel CheckOnly use #2 diesel fuel when refueling Refueling ProcedureCoolant Antifreeze/Summer Coolant/ Water Remove fuel cap from filler neck and fill tank FigureAir Cleaner Fan Belt Tension Cleaning the RadiatorBattery Operation in Freezing WeatherWiring Battery Cable InstallationWhen connecting battery do the following AlternatorStarting Before StartingStarting Manual Engine’s exhaust contains harmful emissionsIgnition Switch Start Position Emergency Shutdown Procedure Light tower operation Normal Shutdown ProcedureAutomatic Shut-down System General Inspection Air Cleaner MaintenanceAir Cleaner with Dust Indicator Fuel Addition Cleaning Inside the Fuel TankRemoving Water from the Fuel Tank Fuel Tank InspectionCheck Oil Level Radiator CleaningReplacing Oil Filter Flushing Out Radiator and Replacing CoolantGenerator Wiring Diagram Generator Wiring DiagramEngine Wiring Diagram Engine Wiring DiagramSymptom Possible Problem Solution Troubleshooting GeneratorPage Explanation of Code in Remarks Column To 3 units Suggested Spare PartsQty Description Generator Assy 7961025004 B11102006020601822630 8001070003Control box Assy 0601870430 M12130011020021004075 0601842384Control box Assy 0601808985 AC AMMETER, 0~50A/100A5A 0601801040 06018076410601806859 0601801041Engine and Radiator Assy 8972606490 M19232001042944566410 M1303200304Engine and Radiator Assy 0150000018 M92002000040016906020 0199900600Output Terminal Assy M9220000004 M1230700003M9220000104 0039308000Battery Assy B9310500014 0602220185M9103000304 0602220920Muffler Assy M1333002803 M13301008038970420280 M1333200014Fuel Filter Assy 14A 8980374810 8943672922M1366700104 8970398340Enclosure Assy M1413400004 M1413003302M1423002302 M1493104903Enclosure Assy Part Name QTY Rubber Seals Assy REMArks Nameplate and Decals Assy M1550000204 M1550000104M1550003312 M1550003412Freight Policy Terms and Conditions of Sale PartsPage HERE’S HOW to GET Help

dca25ssiu3 specifications

The Multiquip DCA25SSIU3 is a powerful and reliable generator that exemplifies performance and efficiency in portable power solutions. As part of Multiquip’s DCA series, this generator is designed with a focus on providing optimal power for construction sites, events, emergency backup, and various industrial applications.

One of the key features of the DCA25SSIU3 is its robust 25 kVA output, which is capable of handling significant loads with ease. This makes it suitable for powering multiple tools and equipment simultaneously, ensuring that operators can complete their tasks without interruption. The generator is equipped with a durable and quiet-running engine, which contributes to its reputation for reliability and ease of use.

In terms of technological advancements, the DCA25SSIU3 incorporates advanced inverter technology. This feature ensures that the output power is stable and clean, making it ideal for sensitive electronic equipment. This technology not only enhances performance but also increases fuel efficiency, allowing for longer operational periods between refueling.

Another notable characteristic of the DCA25SSIU3 is its compact design, coupled with a user-friendly control panel. The generator is designed to be portable, with integrated lifting points that make it easy to transport across various job sites. The control panel features clear indicators for easy monitoring of power output, fuel level, and operational status, empowering users to operate the generator with confidence.

Moreover, the DCA25SSIU3 is built with durability in mind. It features a rugged enclosure that protects vital components from the elements, including rain, dust, and debris. This design ensures that the generator can withstand tough job site conditions while providing reliable power.

In terms of safety, the DCA25SSIU3 is engineered with multiple protective features, including low oil shutdown and overload protection, which helps to prevent damage to the generator and connected equipment.

Overall, the Multiquip DCA25SSIU3 stands out as a robust, efficient, and reliable choice for those seeking a dependable portable power solution that meets the demands of various environments and applications.
Top Page Image Contents