Land Pride ZRP44, ZRP52 manual Left/Right Fuel Tank Valve, Blade Engagement Switch, Control Levers

Page 11

Land Pride

Section 2 Operating

Table of Contents

Left/Right Fuel Tank Valve

Refer to Figure 2-3:

The mower is equipped with a Left/Right Fuel Tank Valve located on the right side behind the seat. It determines which fuel tank the mower is operating from. It is not important which fuel tank the mower is using.

Left/Right Fuel Tank Switch

Figure 2-3

Blade Engagement Switch

Refer to Figure 2-2:

The Blade engagement switch engages the blade clutch which engages deck blades. Pull the switch up to engage and push switch down to disengage the blades.

IMPORTANT: Never engage blades with engine running at high rpm or when the deck is under load. Clutch, belts or deck could be damaged.

Control Levers

Refer to Figure 2-4:

These levers control the mower’s speed, direction, neutral lock and park brake. Levers are used to steer, accelerate, decelerate, and change direction. The mower will not move when the engine is on, drive pumps are operating and the control levers are in the park brake position (out) (Figure 2-5).

Control Levers

21041

Control Levers

Figure 2-4

The Parking Brakes are applied by moving the control levers from the Neutral Position (Figure 2-4) to an outward position (Figure 2-5). Each rear wheel brake operates independently of the other.

!WARNING!

In the event of a system failure while mowing, engage both parking brakes to stop or slow mower.

!WARNING!

The parking brake is not designed to hold the mower on steep slopes.

Control Levers

20672

Control Levers in Parking Brake Position

Figure 2-5

Deck Lift Pedal

Refer to Figure 2-6:

The deck lift pedal is used to raise or lower the deck. Push on the pedal to raise the deck and then place the deck height locking pin into the desired cutting height hole.

Push the deck lift pedal to raise the deck when going over obstructions.

Deck Height

Deck Lift

Locking Pin

Pedal

 

20670

Deck Lift Pedal

Figure 2-6

7/14/08

ZRP44 & ZRP52 Zero Turning Radius Mowers 356-117M

9

Image 11
Contents Accu-Z Razor ProTable of Contents For Your Protection Important Safety InformationBe Aware of Signal Words Keep Riders Off MachinerySafety at All Times Practice Safe MaintenanceAvoid High Pressure Fluids Hazard Prepare for EmergenciesWear Protective Equipment 818-543C 838-303C838-305C 838-306C838-399C 838-307C838-308C 838-310CIntroduction Using This ManualApplication Owner AssistanceRefer to Figure Control Lever & Seat AssemblyAssembly and Set-Up Throttle Control Ignition SwitchControls OperatingDeck Lift Pedal Blade Engagement SwitchLeft/Right Fuel Tank Valve Control LeversOil Pressure Light Safety Start Interlock SystemInstrumentation Engine StartingRefer to -8 on Driving the MowerMoving Mower with Stalled Engine Operating Suggestions Operating Instructions Mower Deck OperationSteering Linkage AdjustmentsIntroduction Torque ValuesControl lever stops Control Lever Neutral AdjustmentSteering Dampener Control Lever AdjustmentPark Brake Adjustment Control Lever Position Travel Slot Park Brake Outside Edge Deck Drive Belt Adjustment Hydro-Drive Belt AdjustmentDeck Level Adjustments Engine RPM SettingDeck Leveling and Height Adjustment Tire Inflation ChartNut Deck Lift Threaded Rod Refer to Refer to Figure Deck Cutting Height AdjustmentAnti-Scalp Rollers Hydraulic Oil Heat Exchanger Maintenance and LubricationVerify Safety Start Interlock System Daily Solid fill tires are not to be used on the Razor Pro mowers MaintenanceTires Electrical System Hour MeterLubrication Hydraulic System Access to Engine & Hydraulic PumpsBurnishing the Electric Clutch Fuel System Refer to -8A and -8B Draining the fuel tankChanging fuel filters Over Servicing Engine Oil and FilterEngine Air Filter Refer to -9A and -9BRefer to -11 and Figure Engine Air Filter Service ProcedureGeneral Engine Maintenance Belt ReplacementDeck Belt Drive Layout Deck Drive BeltIntegrated Pump/Motor Drive Belt Refer to -11, -12, and FigureRefer to -14 and -15 on Mower Blade MaintenanceMower Blade Removal and Sharpening New Season Preparation Preparation of Engine for StorageZRP44 & ZRP52 Razor Pro Riding Mowers General Specifications Specifications and CapacitiesZRP44 & ZRP52 Razor Pro Riding Mowers Engine Specifications Hydraulic Pump Drive Brake ServiceSafety Features IndicatorsZRP44 & ZRP52 Razor Pro Riding Mowers Features and BenefitsFeatures Troubleshooting Oil in reservoir smells rancid Mower creeps when steering controlMower creeps when parking brake Oil Light is on when engine isTire Appendix40 ZRP44 & ZRP52 Zero Turning Radius Mowers 356-117M 14/08 Hydraulic Wheel Motors and Pumps 2 years on Parts and Labor WarrantyCorporate Office P.O. Box Salina, Kansas 67402-5060 USA