Driving the Mower, Refer to -8 on | Land Pride ZRP44, ZRP52 specs

Land Pride

Section 2 Operating

Table of Contents

IMPORTANT: The engine starter should not be operated for periods longer then 30 seconds at a time. An interval of at least two minutes should be allowed between such cranking periods to protect the starter from overheating and burn-out.

5.Perform test to make sure safety start interlock system is operating properly. Refer to “Safety Start Interlock System” on page 10.

6.As soon as engine begins to run, check to make certain the oil warning light is off. If not, stop engine immediately and check for the cause. Refer to “Section 7 Troubleshooting” on page 37.

7.Allow the engine to idle a few minutes before advancing the throttle and/or engaging the blade clutch.

8.Before stopping the engine, place the control levers in the brake position, disengage the blade engagement, and throttle back to low idle for a couple of minutes; then rotate ignition key counter-clockwise to the OFF position. Remove the key from switch before leaving the seat.

!WARNING!

Never leave the machine unattended with key in ignition switch.

IMPORTANT: Following repairs, always make certain the two bypass valve stems are returned to their operating position before running the mower.

Driving the Mower

!DANGER!

Never make sudden stops or sudden reversing of direction, especially when going down a slope. The steering is designed for sensitive response. Rapid movement of the control levers in either direction could result in a reaction of the mower that can cause serious injury.

Steering

Refer to Figure 2-8 on page 12

After starting engine, engage the control levers and steer as follows:

•To Go Forward:

Push control levers forward an equal distance.

•To Go in Reverse:

Pull control levers rearward an equal distance.

•To Turn Left:

Move the right control lever farther forward from neutral than the left control lever.

Moving Mower with Stalled Engine

Refer to Figure 2-7

The mower hydro-drives are equipped with bypass valves for moving the mower when the engine is inoperable. The valve stems to the bypass valves are located near the top of the hydraulic pumps and are identified as a hex stud.

Before moving the unit, turn each bypass valve stem counter clockwise one-half to one revolution and place the control levers in neutral position.

Do not tow the machine. Move it by hand or use a winch to load it on a trailer for transporting.

When transporting on another vehicle, the tractor should be facing forward and it must be secured.

•To Turn Right:

Move the left control lever farther forward from neutral than the right control lever.

•To Pivot Turn:

Move one control lever forward and the other control lever back of neutral, this will allow the drive wheels to counter- rotate.

Controlling the Speed

!WARNING!

In the event of a system failure while mowing, engage both parking brakes to stop or slow mower. Refer to Figure 2-5.

Bypass valve

21054

Bypass Valve

Figure 2-7

!DANGER!

When going in reverse push forward gently on control levers and avoid sudden movement. Any sudden movement could cause the front of the mower to come off of the ground resulting in possible loss of control.

To Stop or decrease speed:

Move control levers to neutral. When going forward pull back gently on control levers. When going in reverse push forward gently on control levers.

To Increase Speed:

Increase control levers equal distance from neutral. The farther forward control levers are from neutral, the faster the mower will travel forward. The farther back the control levers are from neutral, the faster the mower will go in reverse.

7/14/08

ZRP44 & ZRP52 Zero Turning Radius Mowers 356-117M