Land Pride BH2585 manual Transport Lock, Lower Link Hitch Bracket Installation

Page 15

Land Pride

Table of Contents

Section 1 Assembly and Set-Up

Lower Link Hitch Bracket Installation

1.Install right hand (#2) and left hand (#1) lower link hitch brackets with bolts (#3) ﬂat washers (#5) and lock nuts (#4). Assemble hitch pins (#7) to hitch brackets as shown. Refer to Figure Figure 1-8.

Lower Hitch Brackets

5.Raise the boom to take the tension off of the boom lock so you can release the lock. Refer to Figure 1-6.

Transport Lock

20566

Transport Lock

Figure 1-6

6. Remove the pin (#4) and connect dipper cylinder (#3),

re-install pin (#4), bolt (#1) & lock nut (#2). Refer to

Figure 1-7.

Figure 1-8

19369

2.Back tractor against backhoe in mounting position.

3.Connect tractor’s upper 3-point to backhoe.

4.Apply hydraulic power to the backhoe.

Dipper Cylinder

Installation

Figure 1-7

20569

!CAUTION!

Keep all people clear of your work area during the next steps. Until the backhoe is securely mounted, the operator should make sure that no portion of his body is beneath any part of the backhoe.

10/28/05

13

Image 15

Contents Backhoes Table of Contents For Your Protection Important Safety InformationLook For The Safety Alert Symbol Be Aware Signal WordsKeep Riders Off Machinery Use Safety Lights and DevicesTransport Machinery Safely Transporting the Loader and AttachmentAvoid High Pressure Fluids Hazard Practice Safe MaintenancePrepare for Emergencies Wear Protective Equipment838-378C 838-379C 838-380C818-339C 839-933C 839-932C Serial Number Plate Using This ManualApplication Owner AssistanceBackhoe Operation, Maintenance & Safety Tips Skid Steer Requirements Power Beyond Hydraulic SystemsAssembly and Set-Up Tractor RequirementsClosed Center Hydraulic Systems Power Beyond & Closed Center KitIndependent PTO Hydraulic Pump System Choose the Appropriate HosingBackhoe Independent Hydraulic Systems Main Frame Boom Cylinder Inside Boom Stabilizer Cylinder For All TractorsFor John Deere Tractors Mounting The BackhoeTransport Lock Lower Link Hitch Bracket InstallationBackhoe Stabilizer Kit Installation Seat Assembly Bucket InstallationSkid Steer Hook-Up Optional Equipment Assemblies Locking BarRipper Tooth Operating Instructions Preparing For OperationOperating The Backhoe Transporting The BackhoeControl Functions BoomDipper Stick And Bucket Dipper Stick & Boom Angle Digging SuggestionsDigging at the Correct Angle Observe the following cautions while diggingBucket Angle Storage MaintenanceBucket Tooth Replacement Maintenance and LubricationBucket Cylinder Base End LubricationBucket Pivot Bucket Pivot End of StickBoom Pivot Unerneath at end of Boom Dipper Stick Cylinder Base EndBoom Cylinder Rod End Boom Pivots Both SidesBoom Swing Pivot Boom Cylinder Base EndStabilizer Cylinder Rod End Both Sides Stabilizer Arms Both SidesBoom Swing Cylinder Base End Boom Swing Cylinder Rod End Both SidesSpeciﬁcations and Capacities BH25 Series BackhoesBH2585 Features Benefits Features and BeneﬁtsTroubleshooting Performance Problem Cause SolutionLoad drops when valve Hydraulic System· m Ft-lb Mm x pitch Torque Values Chart For Common Bolt SizeAppendix In-tpiWarranty Corporate Ofﬁce P.O. Box Salina, Kansas 67402-5060 USA