OTHER FUNCTIONS
LUMINOUS BUTTONS
The buttons on this remote controller are designed to remain luminous in dim lighting conditions. If the buttons are no longer luminous when the remote controller is used in low light, recharge them by placing it near a fluorescent or other light source for a sufficient amount of time. This should return the buttons to their luminous condition.
SETUP
Switch the
1.While pressing the MEMO button ⁄6, press the OK Cursor button ⁄0. This will switch the remote controller to the Setup mode.
CH | OK | VOL |
C D | DVD | |||
DSS | T V |
| VCR | AUX |
L D | TUNER | TAPE | AMP | |
CLEAR | MEMO |
| GUIDE | MUTE |
AUTO |
| DTS | CS5.1 | 6.1 |
1 | 2 | 3 | 4 | 5 |
DSP | 2CH | OSD | SLEEP |
The Setup mode includes the following items, which may be accessed using the ^ and v Cursor buttons ⁄0.
•Switch destination (version) (VER)
•Adjust time interval between transmissions of macro operations (MACRO)
VER: Switches the type of preset codes contained in the remote controller .
LCD a displays VER, while LCD b displays either USA or REST. USA means that the
Use the < and > Cursor buttons ⁄0to select the desired version, then press the OK Cursor button ⁄0. This will finish the operation and return the LCD to its original state.
•To cancel the setting, press any button other than the Cursor buttons ⁄0.
•To continue the setting, press the v Cursor button ⁄0.
Note:
Codes that have been programmed will not be erased even if the VER setting is changed, however the NAME indicator displays associated with the Jog Dial command will be changed. Also, the Jog Dial commands for
MACRO: Adjusts the time interval between transmissions of macro operations
When the v Cursor button ⁄0is pressed, LCD a displays MACRO, while LCD b displays STEP.
One square (7) in LCD c is equivalent to an interval of 0.5 seconds, allowing intervals of up to 5 seconds to be set. The remote controller is set at the factory with an interval of 1 second, as indicated by (77&&&&&&&&). Adjust the interval between transmission of operation codes using the ^ and v Cursor buttons ⁄0, then press the OK Cursor button ⁄0.
•To cancel the setting, press any button other than the Cursor button
⁄0.
•To continue the setting, press the v Cursor buttons ⁄0.
BATTERY LIFE
•New batteries will last about 4 months assuming an average of 30 uses per day.
Note:
The batteries shipped with the remote controller are for the purpose of checking function and may not last as long as new batteries.
NUMBER OF LEARNABLE CODES
The remote controller (RC7200SR) uses
ENGLISH
25