Jonsered LT2226 A2 To Start Engine See Fig, Purge Transmission, Automatic Transmission Warm UP

Page 12

OPERATION

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

Be sure freewheel control is in the transmission engaged position.

Sit on seat in operating position, depress brake pedal and set parking brake.

Move attachment clutch to “DISENGAGED” position.

Move throttle control to fast position

Pull choke control out for a cold engine start attempt. For a warm engine start attempt the choke control may not be needed.

NOTE: Before starting, read the warm and cold starting procedures below.

Insert key into ignition and turn key clockwise to “START” position and release key as soon as engine starts. Do not run starter continuously for more than fifteen seconds per minute. If the engine does not start after several attempts, push choke control in, wait a few minutes and try again. If engine still does not start, pull the choke control out and retry.

WARM WEATHER STARTING (50° F and above)

When engine starts, slowly push choke control in until the engine begins to run smoothly. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly.

The attachments and ground drive can now be used. If the engine does not accept the load, restart the engine and allow it to warm up for one minute using the choke as described above.

COLD WEATHER STARTING (50° F and below)

When engine starts, slowly push choke control in until the engine begins to run smoothly. Continue to push the choke control in small steps allowing the engine to accept small changes in speed and load, until the choke control is fully in. If the engine starts to run roughly, pull the choke control out slightly for a few seconds and then continue to push the control in slowly. This may require an engine warm-up period from several seconds to several minutes, depending on the temperature.

AUTOMATIC TRANSMISSION WARM UP

Before driving the unit in cold weather, the transmission should be warmed up as follows:

Be sure the tractor is on level ground.

Release the parking brake and let the brake slowly return to operating position.

Allow one minute for transmission to warm up. This can be done during the engine warm up period.

The attachments can be used during the engine warm- up period after the transmission has been warmed up and may require the choke control be pulled out slightly.

NOTE: If at a high altitude (above 3000 feet) or in cold temperatures (below 32 F) the carburetor fuel mixture may need to be adjusted for best engine performance. See “TO ADJUST CARBURETOR” in the Service and Adjustments section of this manual.

PURGE TRANSMISSION

CAUTION: Never engage or disengage freewheel lever while the engine is

running.

To ensure proper operation and performance, it is recom- mended that the transmission be purged before operating tractor for the first time. This procedure will remove any trapped air inside the transmission which may have de- veloped during shipping of your tractor.

IMPORTANT: SHOULD YOUR TRANSMISSION REQUIRE REMOVAL FOR SERVICE OR REPLACEMENT, IT SHOULD BE PURGED AFTER REINSTALLATION BEFORE OPERATING THE TRACTOR.

Place tractor safely on a level surface - that is clear and open - with engine off and parking brake set.

Disengage transmission by placing freewheel control in freewheeling position (See “TO TRANSPORT” in this section of manual).

Sitting in the tractor seat, start engine. After the en- gine is running, move throttle control to slow position. Disengage parking brake

CAUTION: At any time, during step 4, there may be movement of the drive wheels.

Depress forward drive pedal to full forward position, hold for five (5) seconds and release pedal. Depress reverse drive pedal to full reverse position, hold for five

(5) seconds and release pedal. Repeat this procedure three (3) times.

Shut- off engine and set parking brake.

Engage transmission by placing freewheel control in engaged position (See “TO TRANSPORT” in this sec- tion of manual).

Sitting in the tractor seat, start engine. After the engine is running, move throttle control to half (1/2) speed. Disengage parking brake.

Drive tractor forward for approximately five feet then backwards for five feet. Repeat this driving procedure three times.

Your transmission is now purged and now ready for normal operation.

12

Image 12
Contents LT2226 A2 Safety Rules Safe Operation Practices for Ride-On MowersGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Assembly Unassembled PartsTo Remove Tractor from Carton Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor To Adjust Mower Cutting Height See Fig To Adjust Gauge Wheels See FigUsing the Reverse Operation System To Operate MowerService REMINDER/HOUR Meter Before Starting the EngineTo Operate on Hills Check Engine OIL LevelTo Start Engine See Fig Purge TransmissionAutomatic Transmission Warm UP Mowing Tips Maintenance Lubrication ChartBattery TractorBrake Operation TiresEngine Cleaning MufflerSpark Plugs IN-LINE Fuel Filter See FigService and Adjustments To Install Mower See FigTo Remove Mower See Fig Service and Adjustments To Level Mower To Replace Mower Drive Belt See Fig To Replace Motion Drive Belt See FigTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigTo Check Brake Front Wheel TOE-IN/CAMBERTo Adjust Throttle Control Cable To Adjust Choke ControlTo Adjust Carburetor To Replace Headlight BulbStorage OtherFuel System Engine OILTroubleshooting Points Engine dies when Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX

LT2226 A2 specifications

The Jonsered LT2226 A2 is a state-of-the-art lawn tractor designed to deliver exceptional performance and reliability for homeowners looking to maintain their lawns effortlessly. With a robust construction and an array of advanced features, this model stands out in the competitive market of garden maintenance equipment.

One of the primary features of the LT2226 A2 is its powerful 726 cc engine, which ensures efficient cutting and robust performance across various terrains. The engine is engineered for low emissions, making it an environmentally friendly choice for conscientious users. Its high-speed capabilities allow for quicker mowing sessions without compromising on the quality of cut, thus saving valuable time.

The chassis of the LT2226 A2 is built for durability, featuring a strong, steel frame designed to withstand the rigors of regular use. The tractor’s cutting deck is another notable aspect; the 102 cm / 40-inch cutting width enables the lawn tractor to cover more ground in fewer passes. With adjustable cutting heights, users can customize their grass trimming to suit specific lawn care needs.

One of the standout technologies integrated into the LT2226 A2 is the patented articulated steering system. This feature enhances maneuverability, allowing users to navigate tight corners and obstacles with ease. The ergonomic design of the steering wheel and comfortable seat provides superior driver comfort, reducing fatigue during extended mowing sessions.

Moreover, the LT2226 A2 is equipped with a hydrostatic transmission. This advanced transmission system provides seamless acceleration and deceleration, making it user-friendly, especially for those new to riding lawn tractors. The foot-operated pedals facilitate smooth operation without the need for manual gear shifts.

Additionally, the tractor boasts a mulching function that finely chops the grass clippings and returns them to the lawn, acting as a natural fertilizer. This feature not only helps in reducing lawn waste but promotes healthier grass growth.

Safety is a top priority with the Jonsered LT2226 A2. The tractor is fitted with an automatic brake system that engages when the operator leaves the seat, ensuring a heightened safety feature during operation.

In conclusion, the Jonsered LT2226 A2 is a well-rounded lawn tractor that combines power, efficiency, and user-friendly features. Whether you are a seasoned lawn care enthusiast or a beginner, this model is designed to make your mowing experience smooth and productive. With its blend of innovative technology and comprehensive design, the LT2226 A2 is an excellent investment for maintaining a pristine lawn.