SECTION
DETAIL “A”
DETAIL “B”
DETAIL “C”
Drain
Jets
Drain Plug
Flow Water
Thermometer
Water Temperature Valve
FIGURE 3.4 Filling Tub
Hydromassage
CAUTION
Before starting hydromassage, water level MUST be completely above whirlpool jets otherwise damage to the motor/pump will result.
NOTE: For this procedure, refer to FIGURE 3.5.
1.Close the aerator by rotating the aerator valve two turns clockwise.
2.Open the whirlpool inlet by pushing the inlet plug in.
3.Open all whirlpool jets by pulling the center of the whirlpool jet out or rotating the center counterclockwise.
4.Fill the tub. Refer to Filling Tub on page 26.
5.After water level covers whirlpool jets (Detail “A”) and after bathing the resident, add ICCG Defoamer to bath water. Refer to Defoamer bottle for directions.
6.Push whirlpool On/Off button (Detail “B”) to start whirlpool jets.
7.Adjust the whirlpool aerator for desired water agitation by rotating the whirlpool aerator (Detail “C”).
8.After use, push whirlpool On/Off button to stop whirlpool jets (Detail “B”).
9.Drain tub (Detail “A”).
Part No 1150695 | 27 | Recessed Side Entry Bath Tubs |