Marantz manual Preparing the LN-11S1A, Assembling the MOUNT20

PREPARING THE LN-11S1A

Assemble the anamorphic lens and lens slider using the supplied screws and washers.

Secure the projector to the base plate using the specified screws, and secure the lens slider with anamorphic lens attached to the base plate.

ASSEMBLING THE MOUNT20

Assemble the MOUNT20 by performing the steps below, refer to Figure 8:

MOUNT20 and LN-11S1A Mounting plates

1. Insert Base Plate connectors q into the lateral positioning slots e from the underside of Plate 1.

The lateral positioning slots will give you 2-1/4 inches of lateral adjustment for projector alignment. Refer to Figure 9.

SETUP

2. Base plate connector holes e provide 15 degrees of horizontal rotation adjustment. Attach horizontal adjustment Plate #2 to the projector mount ceiling Plate #1 using the four (4) 5/16-18 inch nuts and washers provided. Refer to Figures 10 and Figure 11 on page 8.

PARTS BEFORE USE

1. Secure the lens slider to the base plate using the supplied machine screws (M3 x 8) in 6 locations.

When attaching to a VP series projector, slide the lens slider to the end as shown in Figure 7 and secure in place.

Plate #1

Plate #2

Plate #1 r

r

w

q

w

e

w

e

q

Plate #2	e
	e

e

e AccessWire

ADVANCED BASIC OPERATION OPERATION NAME OF

Slide this way.

Figure 7

Platea #3

Plate #4

Figure 8

Note:

The MOUNT20 hardware, fasteners, mounting template and parts list are located in a separate shipping carton from the projector. Plate #4 will be used when installing the MOUNT20 with the projector.

Base Plate Connectors q Projector Mount Ceiling Plate #1

Figure 9

Plate #1

Figure 10

Note:

When the EXT10 Extension Pole will be used, attach the “Outside Pole” end to Plate #1 (instead of Plate #2) using four (4) 5/16-18 inch nuts and washers provided. Refer to Figure 12 on page 8.

OPERATION

REMOTE CONTROLLER OTHERS TROUBLESHOOTING SETUP

7