Basic Operation, Turning the Power on | Marantz LN-11S1A specification

BASIC OPERATION

TURNING THE POWER ON

Plug the AC cable of the AC/DC adapter into a power outlet and plug the output plug into the DC jack of the unit. The unit’s power turns on and the POWER ON indicator on the top panel lights blue.

TURNING THE POWER OFF

To turn the unit’s power off, unplug the plug of the AC/DC adapter from the DC jack. The unit’s power turns off and the POWER ON indicator goes out.

Note:

Do not turn the unit’s power off while the anamorphic lens is in motion. Doing so may result in damage to equipment. If you will not be using the unit for an extended period of time, be sure to unplug the AC/ DC adapter from the power outlet.

CONTROLLING THE UNIT USING A TRIGGER INPUT SIGNAL

When 12 V DC is input to the +12 V TRIGGER IN jack, the anamorphic lens moves to the operating position (Refer to Figure 2) and trigger signal input indicator on the top panel lights blue.

When 12 V DC is not input to the +12 V TRIGGER IN jack, the anamorphic lens moves to the opposite end from the operating position (Refer to Figure 1) and trigger signal input indicator goes out.

Figure 1

Figure 2

Note:

Do not move the LN-11S1A lens slider by hand. If the lens slider was moved by hands, it might cause failure.

USING VP-11 OR VP-15 SERIES TRIG. 2 OUTPUT JACK

Trigger cable

LN-11S1A +12 V TRIGGER IN jack

Connect the TRIG. 2 output jack of VP-11 series or VP-15 series to the +12V TRIGGER IN jack of the lens slider.

Display the projector’s setup menu and set Trigger 2 V-stretch to On and turn all other settings Off. (Refer to Figure 3)

Standard 1
Picture Adjust	Auto Power Off		Disable
Fine Menu 1	Trigger 2	Full	Off
Fine Menu 2	Trigger 2	Normal	Off
Input Signal	Trigger 2	Zoom	Off

RGB/HD Adjust	Trigger 2 V-stretch	On
HDMI	Trigger 2 Through	Off
Display	Remote Control
OSD/Blanking	Reset Lamp Life
Config.	Reset All

Figure 3

When V-stretch is set for the projector’s aspect mode, 12 V DC is automatically output from the TRIG. 2 output jack and the anamorphic lens moves to the operating position. (Under the settings given above, 12 V DC is not output from the TRIG. 2 output jack in other aspect modes.)

For example, set the projector as described above. If a movie having 2.35:1 cinemascope size is input from HDMI1 and viewed under “full” aspect mode, a black band will appear at the top and bottom of the screen. Now, change the aspect mode to V-stretch. The black bands at the top and bottom of the screen will disappear, and the movie will be displayed at a 16:9 aspect ratio that ﬁlls the screen. At the same time, 12 V DC is output from TRIG. 2 output jack, the anamorphic lens moves in front of the projector’s lens (operating position), and you can view the movie at the correct aspect ratio of 2.35:1.

ADVANCED BASIC OTHERS TROUBLESHOOTING SETUP OPERATION OPERATION NAME OF PARTS BEFORE USE