ESU Erofe B P F O E MAN Stra CI SAB Arepo N IO T

ESU EROFE B P F O E MAN STRA CI SAB AREPO N IO T

SETUP

3. Install the combined Plates #1 and #2 (or Plate 1 with the EXT10) securely to the Building Structure following all of the Local Building/Construction Codes. Use suitable hardware in adequate quantity and size depending on the installation requirements.

Wire

Access

4. Attach the Horizontal Tilting Plate #3 to the previously combined plates (already installed on ceiling) using the 1/4-20 inch screws provided. Refer to Figures ?? and ??. Install two 1/4-20inch screws with rubber spacers and metal washers part way into the welded metal studs (indicated #1). The newly combined Plate 3 provides 10 degrees of horizontal tilt. After positioning the plate, loosely tighten the screws.

5. Tighten all the recently install hardware and proceed to install the LN-11S1A.

VDEARCELLNOART NOC ET O MER

PUTEGS IN T OOHSEL BUORT AREPO N IO T AREPO N IO T

SRE HT O

Figure 11

EXT10

Plate #3

Plate #1

Figure 12

Caution:

The Projector together with the mounting brackets weighs 59 pounds (26.7kg).

Figure 13

Note:

When the EXT10 Extension Pole will be used, attach the “Inner Pole” end to combined Plate #2 and #3 (instead of Plate #2) using four (4) 5/16-18 inch nuts and washers provided. Refer to Figure 13.

Titing Capability

Figure 14

Figure 15