Mounting the LN-11S1A, On the Floor

Connect the AC/DC adapter’s output plug to the +5 V DC jack on the lens slider. When power is supplied to the LN-11S1A, the POWER ON indicator will light blue.

U E

ROF

EB SETUP

	P	MOUNTING THE LN-11S1A
	F O	(ON THE FLOOR)
	E
	MAN	Mount the assembled LN-11S1A to the projector.
	MAN	Refer to Figure 20.
	STRA
	ARE
	IC
	P
	S
	O
	AB
	N IO	Figure 20
	T
		1. Spread a soft cloth on a stable, horizontal
	V ARE	surface to protect against scratching, and
	V ARE	carefully place the projector upside down
	DE	on the cloth.
	P
	O
	RACELNL	Align the mounting holes on the LN-11S1A
	N	Align the mounting holes on the LN-11S1A
	N	base plate with the lens slider attached
	IO	base plate with the lens slider attached
	AO
	RT
	T	with the two ceiling mount kit mounting
	NOCE	with the two ceiling mount kit mounting
	NOCE	screw holes located on the lens side of
	TO	the projector. Refer to Figure 22. Attach
	MER PA	the projector. Refer to Figure 22. Attach
	MER PA	securely using two M8x10 hexagonal set
	REUTP	screws supplied with the LN-11S1A. Refer
	EO	to Figure 21.
	GS IN	to Figure 21.
	GS IN
	TNIO
	OT
	OHSEL
	BUORT

SRE HT O

Figure 22

Figure 23

2. It is important to completely ﬁnish mounting the projector and making initial settings before mounting and adjusting the LN- 11S1A anamorphic lens. Perform necessary procedures such as focus adjustment while referring to the projector’s user’s guide. Once the required projector settings have been made, proceed with lens mounting and adjustment.

MOUNTING THE LN-11S1A LENS

Mount the lens to the projector, whose operations have already been confirmed, according to the procedure given below.

1. Attach the anamorphic lens unit to the main unit at two locations by passing the supplied decorative screws (M3 x

8)through the spring washers and flat washers. Refer to Figure 24 and 25.

When mounting the lens unit, be sure to mount it so that the anamorphic lens unit does not strike the projector lens when in the operating position.

Figure 24

CONNECTING THE LN-11S1A

Connect the LN-11S1A to a power supply and the projector.

1. Install the AC/DC adapter and attach the AC cable to the AC/DC adapter.

Refer to Figure 26. During use, always use the supplied AC/DC adapter. Never use an AC/DC adapter other than that supplied as it may result in an accident or damage to the equipment.

Figure 26

Note:

Three types of AC cable are supplied with this unit. Use the AC cable appropriate for the region in which the unit will be used.

2. Connect the TRIG. 2 output jack on the VP11 or VP15 series projector to the +12 V TRIGGER IN jack located on the lens slider.

3. Plug the AC cable into a power outlet.

Figure 21

Figure 25