Homelite CSP4518, CSP3816 manual Starting a Cold Engine

Page 15

OPERATION

STARTING A COLD ENGINE:

3.Move the chain brake to the BRAKE position.

NOTE: Set the chain brake by pushing the chain brake lever/hand guard forward (towards the bar) to the brake position. Refer to “Operation – Operating Chain Brake” for additional information.

4.Set the ignition switch to the RUN (I) position.

5.Fully press and release the PRIMER BULB 7 times.

6.Pull CHOKE lever all the way OUT to full position. The partial throttle position is automatically set when the choke lever is set at full choke.

CHOKE LEVER

Fig. 14

STARTER

GRIP

Fig. 15

CHOKE

 

LEVER

Fig. 16

 

STARTER

GRIP

Fig. 17

TRIGGER

RELEASE

RUN POSITION

THROTTLE TRIGGER

Fig. 18

UK - Page 15

Image 15
Contents Save this Manual for Future Reference OPERATOR’S ManualIntroduction Table of ContentsRead ALL Instructions General Safety RulesKeep ALL Parts of Your Body away from the saw Basic Precautions in the CUTTING/ Work Area Specific Safety RulesGeneral Precautions Safety ApparelPull Push Maintenance PrecautionsPush and Pull KICK-BACKSymbol Name Explanation SymbolsSymbols Specifications Features LOW KICK-BACK SAW Chain Understanding Your Chainsaw Safety DevicesOperation SAFE-T-TIPANTI-KICK-BACK Nose GuardKICK-BACK Danger Zone Rotational KICK-BACK PrecautionsChain Brake RUN Position BrakeFilling the Tank Fuel and RefuellingHandling the Fuel Safely Mixing the FuelBrake Position Ignition Switch RUN Primer Bulb Adding OILStarting the Engine Starting a Cold Engine Ignition Switch Stop Position Stopping the EngineStarting a Warm Engine Chain Line Preparing for CuttingProper Grip on Handles Proper Cutting StanceAIR Filter Basic OPERATING/CUTTING ProceduresWork Area Precautions Adjusting the CarburettorAdjusting Idling Speed Operating the Chain BrakeBrake Position RUN Position Felling Trees Hazardous Conditions Keep Bystanders AwayRetreat Path Proper Procedure for Tree Felling Planned Line of FallRetreat Wedge HingeNotch Approx /3 Diameter Trunk Back CUT Hinge Back CUTVertical CUT Loose Section Horizontal KICK-BACK Wedge Removing Buttress RootsBucking Bucking with a WedgeLOG Supported AT ONE END Finishing CUT Bucking Logs Under StressOVER-BUCKING UNDER-BUCKINGFinishing CUT Spring Pole Limbing and PruningCutting Spring Poles Load Second CUTAssembling the BAR and Chain MaintenanceCutters Chain Tensioning Screw Adjusting the Chain Tension Chain MaintenanceFlats on Drive Links Sharpening the Cutters Check for Wear or Damage LEFT-HAND Cutters RIGHT-HAND Correct Less than Maintaining Depth Gauge ClearanceTOP Plate Filing Angle Side Plate AngleLubricating Hole Restore Original Shape by Rounding FrontMaintaining the Guide BAR Maintaining the SAFE-T-TIPNOSE GuardCleaning the AIR Filter Mounting the SAFE-T-TIP Nose GuardTighten 3/4 A Turn Replacing the Sparking Plug Cleaning the Starter UnitCleaning the Engine Checking the Fuel FilterStoring the Chainsaw 1 Month or Longer Cleaning the Spark Arresting SilencerChain Catcher Brake Band Clean the Chain Brake Chain BrakeBAR and Chain Combinations TroubleshootingTroubleshooting Guarantee Statement Rtsa / Rtuk / RTG WarrantyRyobi Technologies GmbH