Homelite CSP3816, CSP4518 manual Symbols

Page 8

SYMBOLS

 

Petrol

Use unleaded petrol intended for motor vehicle use

 

 

 

with an octane rating of 87 [R + M] / 2) or higher.

 

 

 

 

Oil

Use 2-cycle oil for air-cooled engines.

 

 

 

 

Mix Petrol and Oil

Mix the fuel mix thoroughly and also each time

 

 

before refuelling.

 

 

 

SAVE THESE INSTRUCTIONS

UK - Page 8

Image 8
Contents OPERATOR’S Manual Save this Manual for Future ReferenceTable of Contents IntroductionGeneral Safety Rules Read ALL InstructionsKeep ALL Parts of Your Body away from the saw Specific Safety Rules General PrecautionsSafety Apparel Basic Precautions in the CUTTING/ Work AreaMaintenance Precautions Push and PullKICK-BACK Pull PushSymbols Symbol Name ExplanationSymbols Specifications Features Understanding Your Chainsaw Safety Devices OperationSAFE-T-TIPANTI-KICK-BACK Nose Guard LOW KICK-BACK SAW ChainKICK-BACK Precautions Chain BrakeRUN Position Brake KICK-BACK Danger Zone RotationalFuel and Refuelling Handling the Fuel SafelyMixing the Fuel Filling the TankStarting the Engine Brake Position Ignition Switch RUN Primer BulbAdding OIL Starting a Cold Engine Starting a Warm Engine Ignition Switch Stop PositionStopping the Engine Preparing for Cutting Proper Grip on HandlesProper Cutting Stance Chain LineBasic OPERATING/CUTTING Procedures Work Area PrecautionsAdjusting the Carburettor AIR FilterBrake Position RUN Position Adjusting Idling SpeedOperating the Chain Brake Retreat Path Felling Trees Hazardous ConditionsKeep Bystanders Away Retreat Proper Procedure for Tree FellingPlanned Line of Fall Hinge Notch Approx /3 Diameter Trunk Back CUTHinge Back CUT WedgeRemoving Buttress Roots BuckingBucking with a Wedge Vertical CUT Loose Section Horizontal KICK-BACK WedgeBucking Logs Under Stress OVER-BUCKINGUNDER-BUCKING LOG Supported AT ONE END Finishing CUTLimbing and Pruning Cutting Spring PolesLoad Second CUT Finishing CUT Spring PoleMaintenance Assembling the BAR and ChainCutters Chain Tensioning Screw Flats on Drive Links Adjusting the Chain TensionChain Maintenance Sharpening the Cutters Check for Wear or Damage LEFT-HAND Cutters RIGHT-HAND Maintaining Depth Gauge Clearance TOP Plate Filing AngleSide Plate Angle Correct Less thanRestore Original Shape by Rounding Front Maintaining the Guide BARMaintaining the SAFE-T-TIPNOSE Guard Lubricating HoleTighten 3/4 A Turn Cleaning the AIR FilterMounting the SAFE-T-TIP Nose Guard Cleaning the Starter Unit Cleaning the EngineChecking the Fuel Filter Replacing the Sparking PlugCleaning the Spark Arresting Silencer Chain Catcher Brake Band Clean the Chain BrakeChain Brake Storing the Chainsaw 1 Month or LongerTroubleshooting BAR and Chain CombinationsTroubleshooting Warranty Guarantee Statement Rtsa / Rtuk / RTGRyobi Technologies GmbH