Marantz SR9200 manual Basic Operation Tuner, Listening to the Tuner, Preset Memory

BASIC OPERATION (TUNER)

DIRECT FREQUENCY CALL

ENGLISH	LISTENING TO THE TUNER
	Frequency scan step for AM is selectable.
	Default setup is 10 kHz step, if your country’s standard is 9 kHz step,
	touch “AM” button on the remote more than 6 seconds. Scan step will
	change.
	Note:
	• Preset memory for the tuner will clear by changing this setup.

1.

2. 3.

AUTO TUNING
3.	2.	1.
		1.
		2.

(USING THE SR9200)

1. To select tuner and desired band (FM or AM), press the TUNER button on the front panel.

2. Press the AUTO-TUNEbutton on front panel, “AUTO TUNING” appears on the display.

3. Rotate the GYRO TUNING dial.

4. Automatic searching begins then stops when a station is tuned in.

(Using the remote control unit)

1. To select tuner and desired band (FM or AM), tap desired band FM or AM on the remote.

2. Touch Tuning^ or Tuningv more than 1 second on the remote.

3. Automatic searching begins then stops when a station is tuned in.

If tuning does not stop at the desired station, use to the “Manual tuning” operation.

MANUAL TUNING

3.2. 1.

1.

2.

(USING THE SR9200)

1. To select tuner and desired band(FM or AM), press the TUNER button on the front panel

2. Press the F/P(Frequency/Preset) button on front panel , to appears frequency on the display.

3. Rotate the GYRO TUNING dial to tune in the desired station.

(Using the remote control unit)

1. To select tuner and desired band(FM or AM), tap desired band FM,or AM on the remote.

2. Tap Tuning^ or Tuningv on the remote to tune in the desired station.

1. To select tuner and desired band(FM or AM), tap desired band FM, or AM on the remote.

2. Tap the Freq. Direct on the remote, display will show “FREQ ----”.

3. Input your desired station’s frequency with ten keypad on the remote.

4. The desired station will automatically be tuned.

(FM) TUNING MODE (AUTO STEREO OR MONO)

When in the auto stereo mode, AUTO indicator keeps to light on the display.

The “ST” indicator lights on when a stereo broadcast is tuned in.

At open frequencies, the noise is muted and the “TUNED” and “ST” indicators turn off.

If the signal is weak, it may be difficult to tune into the station in stereo. In such a case, press the T-MODEbutton n the front panel or tap Streo/Mono on the remote control unit.

“AUTO” indicators turn off ,FM stereo broadcasts are received in monaural and the “ST” indicator turns off.

To return to auto stereo mode, press the T-MODEbutton or tap Streo/ Mono on the remote control unit again. AUTO indicator lights on the display.

PRESET MEMORY

With this unit you can preset up to 50 FM/AM stations in any order. For each station, you can memorize the frequency and reception mode if desired.

AUTO PRESET MEMORY

This function automatically scans the FM and AM band and enters all stations with proper signal strength into the memory.

5. 2. 2.4. 3.-2)1. 3.-1)

1. To select FM , press the TUNER button on the front panel.

2. While pressing the MEMO button , rotate the GYRO TUNING dial to up.

“AUTO PRESET” will appear on the display, and scanning starts from lowest frequency.

42