Marantz SR9200 manual Learning Commands, Recording Macros, Learn Sequence

ENGLISH

LEARNING COMMANDS

If an IR code or a brand is not in the database, you can program RC3200A commands by transmitting IR signals from your existing remote controls to RC3200A's learning eye. To do this, place RC3200A and the device's remote control on a flat surface, 1 to 4 inches (2 to 10 cm) apart.

OK	NO GOOD
Top View	Top View	RC3200A
DVD remote
control unit	RC3200A
Side View	Side View
DVD remote		RC3200A
control unit	RC3200A
	DVD remote
	control unit
1 to 4 inches
(2 to 10 cm)

To learn commands from other remote controls, RC3200A has to be in Learn mode. Switching to Learn mode is only possible from a specific device, not from the Device Overview. See “Working with Modes”.

Per device you can learn all soft and hard buttons on the RC3200A, except for:

•the Backlight button;

•the Page Up and Page Down buttons;

•the buttons to navigation bar.

•the Status button.

THE LEARN SEQUENCE

1. Set the RC3200A in Use Mode. See “Working with Modes”.

2. Select the device, e.g. DVD, with the buttons you want to learn. The device screen appears.

3. Press and hold the Mode button for 3 seconds. The Mode screen appears.

4. Tap Learn on the Mode screen.

RC3200A is now in Learn Mode. 'Learn' and the label of the selected device appear at the top of the touch screen.

5. Use, if necessary, the Page Up or Page Down button to go to the next button you want to learn.

6. Press the soft or hard button you want to learn on the RC3200A. The Learn label changes to Learning, which means RC3200A is ready to receive commands from an existing remote control.

The RC3200A will wait for 5 seconds to receive an IR code from another remote control.

Note

When a hard button is pressed to learn, there is no on screen feedback to indicate which button is pressed.

7. Press and hold the button on the existing remote control you want to learn to the RC3200A.

When the RC3200A receives an IR code:

•You hear a confirmation beep;

•The label changes from Learning to OK. The Learn sequence has been successful.

When the RC3200A does not receive an IR code in 5 seconds:

•You will hear an error beep;

•The label changes from Learning to Failed. The Learn sequence has failed.

•RC3200A will return to Learn mode. Return to step 5 of the

Learn sequence to relearn the button.

Tip

You do not have to wait for the OK or Failed to disappear. If you press another button (soft or hard button), the RC3200A Learn sequence immediately goes back to step 5.

8. Go to other pages of the selected device with the Page Up and Page Down buttons.

Repeat steps 6. and 7. until you have copied all the commands of the existing remote control.

9. Press Done when you have finished learning commands to the buttons of your choice.

RC3200A returns to Use Mode. You can try out the new IR codes or select another device to learn.

RECORDING MACROS

A macro allows you to send a sequence of commands using one single button. You can for instance, switch on your TV, turn to a movie channel and prepare your VCR for recording by rewinding the videotape. All this can be done be pressing a single button on your RC3200A.

To record macros, RC3200A has to be in Macro mode.

1. Set the RC3200A in Use Mode. See “Working with Modes”.

2. Press the HOME button. and press the Page Up button once. The HOME screen 2/2 appears.

18