CHECK LISTS
I
PRE-DELIVERY CHECK LIST
Inspect the mower thoroughly after assembly to ensure it is set up properly before delivering it to the customer. The following check lists are a reminder of points to inspect. Check off each item as it is found satisfactory or after proper adjustment is made.
Check that all safety decals are installed and in good condition.
Check that shieMs and guards are properly installed and in good condition.
Check all bolts to be sure they are correctly torqued.
Check that all cotter pins are properly installed.
Lubricate all grease fittings; check to make sure a small amount of grease comes out of seal.
Check that blades have been properly installed.
DELIVERY CHECK LIST
-Inform customer to operate PTO at 2,000 tpm maximum.
-Check mower attitude and belt alignment.
-Show customer how to make adjustments.
-Explain importance of lubrication to customer and point out lubrication points on mower.
-Present the Operator's Manual, and ask customer to become familiar with all sections.
-Explainto customer that when mower is trans- ported on road or highway, safety devices. should be used to give adequate warning to operators of other vehicles.
DAILY CHECK LIST
Lubricate all grease fittings; check to make sure a small amount of grease comes out of seal.
Check that tractor PTO
Check that both side skids, the left side shield and either the discharge chute or right side shield are installed.
Make sure blades are sharp, free of nicks or cracks and are securely fastened.
Make sure all hardware is securely fastened and in good condition.
Check that mower is properly and securely attached to tractor.
Check that all safety decals are installed and in good condition.
Check that shields and guards are properly installed and in good condition.
GENERAL INFORMATION
The purpose of this manual is to assist you in operating and maintaining your mower. Read it carefully. It furnishes information and instructions that will help you achieve years of dependable performance. These instructions have been compiled from extensive field experience and engineering data. Some information may be general in nature due to unknown and varying operating conditions. However, through experience and these instructions you should be able to develop procedures suitable to your particular situation.
The illustrations and data used in this manual were current at the time of printing, but due to possible in- line production changes, your machine may vary slightly in detail.
\
We reserve the right to redesign and changeI the machines as mav be necessarv without notification.
Some lllustratlons In thls manual show the mower wlth shields and guards removed to provide a better view. The mower should never be operated wlth any shleldlng or guards removed.
Throughout this manual, references are made to right and left directions. These are determined by standing behind the equipment facing the direction of forward travel.
Blade rotation is clockwise as viewed from the top of the mower.
3 |