Honda Power Equipment RM752A manual Safety Rules, Maintenance Safety, Storage

Page 7

SAFETY RULES

A ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! A

(Safety Rules continued from previous page)

Operate PTO at 2,000 rpm maximum. Do not operate PTO during transport.

Make sure area behind you is clear before operating in reverse.

Do not operate on steep slopes.

Do not stop, start or change directions suddenly on slopes.

Use extreme care and reduce ground speed on slopes and rough terrain.

Watch for hidden hazards on the terrain during operation.

Stop mower and tractor immediately upon striking an obstruction. Turn off engine, remove key, inspect and repair any damage before resuming operation.

Block mower securely before working under- neath.

Disengage power to mower, lower to ground, stop engine, set parking brake and remove key before dismounting tractor.

MAINTENANCE SAFETY

Always wear relatively tight and belted clothing to avoid entanglement in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hands, hearing and head.

HTurn tractor engine off, remove key and lower mower to ground before performing-anyservice or maintenance.

BIO& mower securely before working under- neath.

Keep all persons away from operator control area while performing adjustments, service or maintenance.

Make certain all movement of mower compo- nents has stopped before opening blade access cover.

Frequently check blades. They should be sharp, free of nicks and cracks and securely fastened.

Your dealer can supply genuine replacement blades. Substitute blades may not meet original equipment specifications and may be dangerous.

Periodically tighten all bolts, nuts and screws and check that all cotter pins are properly installedto ensure mower is in a safe condition.

Ensure all safety decals are installed and in good condition.

Ensure shields and guards are properly installed and in good condition.

STORAGE

Block mower securely for storage.

NOTES

SR I1

F-7756 (10-89)

5

Image 7
Contents Page Page Table of Contents SpecificationsIntroduction Daily Check List General InformationPRE-DELIVERY Check List Delivery Check ListTraining Operational SafetyPreparation Maintenance Safety Safety RulesStorage Replace Immediately If Damaged Safety DecalsDo not Operate Shield MissingHardware ABBREVlATlONS Torque ChartBolt Head Markings Recommended Torque in Foot Pounds Newton-MetersLeft Side Skid and Shield Installation AssemblyRight Side Skid Installation figure Front Corner Baffle Installation figureRight Side Shield & Baffle Installation Discharge Chute Installation figureCheck Chain Installation figure Top Link Pivot Installation figureDrive Shaft Installation 7756 Operation Attaching Mower to Tractor Cutting Height Adjustment figureImportant Notice Removing Mower from Tractor Tube assemblyImportant Notice Pre-Operation Check ListOperating Technique Uneven Terrain Lubrication Information figure Owner ServiceBlade Removal figure Blade Installation figureBelt Replacement figure Blade ServicingCorrect Incorrect Blade Spindle Removal Blade Spindle Disassembly figureBlade Spindle Assembly figure Spindle RepairApart Drive Spindle Removal figure Blade Spindle InstallationDrive Spindle Disassembly figure Drive Spindle Assembly figureUniversal Joint Repair figures 18 Drive Spindle InstallationAssembly 7756 10-89 Problem Possible Cause Trouble ShootingIndex to Parts Lists Main Frame Assembly Mllsaci Mounting Frame Assembly NQ DescriDtion Rear Drive 8t Shield Assembly Front Drive & Shield AssemblyCW Blade Spindle Assembly Drive Spindle AssemblyDealer Set-Up Instructions IndexTelephone 404